1981 Chevrolet El Camino Ss Standard Cab Pickup 2-door 5.7l 350 Small Block on 2040-cars

Auto blog

Audi S4 drivers are the most accident-prone, insurance report says

Culling data from more than 4.6 million automobile insurance applications, researchers at the Insurify insurance comparison marketplace picked a winner — or more to the point, a loser — in its determination of the car model with the most accidents so far in 2023: the Audi S4. Why does the sporty, luxury-class German sedan rank so high (or so low)? The organization found that S4 drivers, piloting a car with almost 350 horsepower, are among those who collect the most speeding tickets, and that they get into accidents at a rate 54 percent higher than the national average. If the S4 isnÂ’t a surprise with an at-fault accident rate of 11.7 percent, consider the “family friendly” brand that appears three times on the Insurity list: Subaru. It is represented by three models, including the turbocharged WRX and XV Crosstrek, and at the better-performing bottom of the list, the Subaru Impreza, with an accident rate of 10.3 percent.  In 2023, 7.6 percent of U.S. drivers were involved in at least one at-fault accident in the prior seven years. For drivers of cars on this list, the average at-fault accident rate was 10.5 percent, meaning these drivers are 1.4 times as likely to have an at-fault accident on record. According to its statement, the Insurity data science team explored key safety features, driver behavior, and Insurance Institute for Highway Safety (IIHS) evaluations to pinpoint possible reasons behind these carsÂ’ high accident rates. Following is the list, counting down to the models with most reported accidents: 10. Subaru Impreza (percentage of drivers with a prior at-fault accident on record: 10.3 percent; MSRP base model): $19,795) 9. Kia Niro (percentage of drivers with a prior at-fault accident on record: 10.4 percent; MSRP base model): $26,590) 8. Chevrolet Silverado LD (percentage of drivers with a prior at-fault accident on record: 10.4%, MSRP base model): $34,500) 7. Subaru XV Crosstrek (percentage of drivers with a prior at-fault accident on record: 10.5 percent, MSRP 6. Subaru WRX.(percentage of drivers with a prior at-fault accident on record: 10.7% MSRP base model): $29,605) 5. Toyota GR86 (percentage of drivers with a prior at-fault accident on record: 10.8 percent MSRP base model): $29,900) 4. Hyundai Veloster N (percentage of drivers with a prior at-fault accident on record: 10.9 percent; MSRP base model): $32,500) 3.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.