Find or Sell Used Cars, Trucks, and SUVs in USA

1971 El Camino on 2040-cars

Year:1971 Mileage:89435
Location:

Corpus Christi, Texas, United States

Corpus Christi, Texas, United States
Engine:Custom-Total Precision Engines
Vehicle Title:Clear
Condition:
New: A vehicle is considered new if it is purchased directly from a new car franchise dealer and has not yet been registered and issued a title. New vehicles are covered by a manufacturer's new car warranty and are sold with a window sticker (also known as a “Monroney Sticker”) and a Manufacturer's Statement of Origin. These vehicles have been driven only for demonstration purposes and should be in excellent running condition with a pristine interior and exterior. See the seller's listing for full details. ...
VIN (Vehicle Identification Number)
: 136801K223373
Year: 1971
Make: Chevrolet
Drive Type: TH3 Automatic Transmission with Kit
Model: El Camino
Mileage: 89,435
Trim: Stock

1971 Chevrolet El Camino

Vin# 136801K223373 89,435 miles

Custom Built 350 Engine by Total Precision Engines- California

Bored and honed 0.040” over with torque plates
Squared deck
Rebuilt and balanced rods with ARP bolts
Has 305 cylinder heads
Bronze valve guides and 3 angle valve job
9.5 to 1 compression ratio
Dished pistons with Moly rings
Clevite bearings, 10/10 rod and crank journals
Fel Pro Gaskets
Melling Oil Pump with a new shaft pickup
Camshaft: 204’/ 214’ at 0.050, 0.420/0.003 lift with112’ lobe center
Balanced and blueprinted
New Vintage Air air conditioning and heating unit
TH35 Automatic Transmission with kit
Power disc brakes- new rotors, bearings, lines, etc.
New rear drums, shoes, hardware
Large 3 core radiator
Full length Ceramic Coated Headers
2 1/2 ” Stainless Pypes Exhaust with an X pipe
All new shocks
All new fuel lines
All new key cylinders with new ignition switch and turn signals
15 x 18 Corvette Rally wheels with new tires
All trim replaced and polished
New window and door seals
New driver and passenger side glass
New stainless steel trim on bed rails
New full bed liner
Car has two grills, original and hot rod- shown with both

Has been kept in museum atmosphere of conditioned air. It is part of a private collection. Runs like a top

 

Auto Services in Texas

Your Mechanic ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automotive Tune Up Service
Address: 11402 Perrin Beitel Rd, Cibolo
Phone: (210) 590-3260

Yale Auto ★★★★★

Auto Repair & Service
Address: 2510 Yale St, Aldine
Phone: (281) 607-1252

Wyatt`s Discount Muffler & Brake ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Mufflers & Exhaust Systems
Address: 2506 Old Iowa Park Rd, Iowa-Park
Phone: (940) 766-6393

Wright Auto Glass ★★★★★

Auto Repair & Service, Windshield Repair, Towing
Address: 322 E Northwest Hwy, Bartonville
Phone: (817) 421-2834

Wise Alignments ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Oil & Lube
Address: 3172 S Fm 730, Newark
Phone: (866) 595-6470

Wilkerson`s Automotive & Front End Service ★★★★★

Auto Repair & Service
Address: 305 N East St, Haltom-City
Phone: (817) 275-2451

Auto blog

China's rise, global restructuring wither GM's Korea division

Wed, Jan 7 2015

An article in the Daily Kanban suggests the sun is setting on GM Korea, and it could already be well into dusk. GM Korea came about when General Motors, along with co-investors SAIC and Suzuki, bought Daewoo Motors from parent company Daewoo Group in 2001; it had a previous tie-up with GM, a joint venture that ended in 1992, although Daewoo cars were based on GM cars until 1996. Over the decade following the purchase, it became such an important part of operations that it was renamed GM Korea in 2011, "to reflect its heightened status in [the] global operations of GM." Just two years later, the printed rumors were that the subsidiary responsible for a fifth of Chevrolet's global production could be shutting down. The division's sales were down almost 21 percent through November of last year, counting domestic South Korean sales, exports, and CKD – Complete Knock Down – products. That makes the labor strife, already an issue for four years, even more acute, reports say the subsidiary will lose $36 million a year if it can't get the job and wage cuts it wants, and government concessions can't make up for the losses. And it gets worse, so head over to Daily Kanban to read the rest of the story.

This 450-hp electric Lotus Evora is powered by Tesla and Chevrolet

Tue, May 9 2017

When someone mentions an electric Lotus, the first thing that comes to mind is the Tesla Roadster, the California-based automaker's first vehicle. That car started life as an Elise before being heavily massaged and adapted by Tesla's engineers. In a similar spirit, the people at Onpoint Dyno are close to finishing Blue Lightning, a track-ready all-electric Lotus Evora. Blue Lightning uses a Tesla drive unit and a Chevrolet Volt battery pack, both mounted in the middle in place of the Evora's 3.5-liter Toyota V6. It's putting down about 450 horsepower at the wheels. The car was built for time attack sessions, so power is fed through custom forged wheels and super sticky Pirelli PZero Trofeo R tires, the same ones found on the last Chevrolet Camaro Z/28. There is a custom digital instrument cluster in place of the Lotus gauges. There's also a regen paddle on the left side of the steering wheel. With a full charge, Blue Lighting should go about 120 miles. While the car runs under its own power, it's only about 90 percent complete. It has no power steering, no firewall in between the seats and the motor and battery pack, no A/C, and a large hole where the shift lever used to be. Other final touches include fine-tuning the brakes and suspension. There is also a custom rear bumper coming that should make it look more like the new Lotus Evora 400. Onpoint Dyno expects the car to hit the track in the next month or so. Related Video:

Foreign automakers pay from $38 to $65 per hour to non-union workers

Sun, Mar 29 2015

As leaders for the United Auto Workers gather in Detroit for their Special Convention on Collective Bargaining to work out the negotiating stance for this year's new labor agreements with the Detroit 3 automakers, what they most want to do is figure out how to eliminate the two-tier wage scale. However, the lower Tier 2 wage has allowed the domestic automakers to reduce their labor costs, hire more workers, and compete better with their import competition. As it stands, per-hour labor rates including benefits are $58 at General Motors, $57 at Ford, and $48 at Fiat-Chrysler – a reflection of FCA's much greater number of Tier 2 workers. The Center for Automotive Research released a study of labor rates (including benefits) that put numbers to what the imports pay: Mercedes-Benz pays the most, at an average of $65 per hour, Volkswagen pays the least, at $38 per hour, and BMW is just a hair above that at $39 per hour. Among the Detroit competitors, Honda workers earn an average of $49 per hour, at Toyota it's $48 per hour, Nissan is $42 per hour, and Hyundai-Kia pays $41 per hour. The lower import wages are aided by their greater use of temporary workers compared to the domestics. Automotive News says the ten-dollar gap between those foreign camakers and the domestics turns out to about an extra $250 per car in labor, which adds up quickly when you're pumping out many millions of cars. That $250-per-car number is one that, come negotiating time, the Detroit 3 will want to reduce, as the UAW is trying to raise both Tier 1 and Tier 2 wages. Another wrinkle is that the domestic carmakers are considering the wide adoption of a third wage level lower than Tier 2. Some workers who do minor tasks like assembling parts trays kits and battery packs already make less than Tier 2, but the UAW will be quite wary about cementing yet another wage scale at the bottom of the system while it's trying to fight a bigger battle at the top. News Source: Automotive News - sub. req., BloombergImage Credit: AP Photo/Erik Schelzig Earnings/Financials UAW/Unions BMW Chevrolet Fiat Ford GM Honda Hyundai Kia Mercedes-Benz Nissan Toyota Volkswagen labor wages collective bargaining labor costs