Low Miles, Automatic, Cruise Control, Pwr Windows/locks, 1-owner 12548 on 2040-cars

Auto blog

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

This is your 2014 Chevrolet SS

Think you've waited long enough for this? If so, then you'll want to savor the high-res photos we've so far been given of the 2014 Chevrolet SS, the first rear-wheel-drive performance sedan from The Bowtie in 17 years.
We all know its our version of the brand new VF-model Holden Commodore, but what's under the hood that earns the appellation "performance?" A 6.2-liter LS3 V8 engine producing 415 horsepower and 415 pound-feet of torque. That's 35 hp and lb-ft less than the same engine is expected to produce in the 2014 Chevrolet Corvette. Chevrolet says the sedan will get from 0-to-60 miles per hour "in about five seconds."
Shifting comes courtesy of a six-speed automatic with paddles on the steering wheel, while stopping arrive via four-piston Brembo calipers up front, a single sliding piston in back. The forged aluminum wheels are 19-inchers all around, each set supporting right around 50 percent of the sedan's weight, and the aluminum hood and trunk are meant to keep the center of gravity low.

This 450-hp electric Lotus Evora is powered by Tesla and Chevrolet

When someone mentions an electric Lotus, the first thing that comes to mind is the Tesla Roadster, the California-based automaker's first vehicle. That car started life as an Elise before being heavily massaged and adapted by Tesla's engineers. In a similar spirit, the people at Onpoint Dyno are close to finishing Blue Lightning, a track-ready all-electric Lotus Evora. Blue Lightning uses a Tesla drive unit and a Chevrolet Volt battery pack, both mounted in the middle in place of the Evora's 3.5-liter Toyota V6. It's putting down about 450 horsepower at the wheels. The car was built for time attack sessions, so power is fed through custom forged wheels and super sticky Pirelli PZero Trofeo R tires, the same ones found on the last Chevrolet Camaro Z/28. There is a custom digital instrument cluster in place of the Lotus gauges. There's also a regen paddle on the left side of the steering wheel. With a full charge, Blue Lighting should go about 120 miles. While the car runs under its own power, it's only about 90 percent complete. It has no power steering, no firewall in between the seats and the motor and battery pack, no A/C, and a large hole where the shift lever used to be. Other final touches include fine-tuning the brakes and suspension. There is also a custom rear bumper coming that should make it look more like the new Lotus Evora 400. Onpoint Dyno expects the car to hit the track in the next month or so. Related Video: