2012 6.2l Auto Carbon_flash on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Junkyard Gem: 1987 Chevrolet Turbo Sprint

Fifteen years ago, I wrote my first-ever automotive article under the name Murilee Martin, and it didn't take me long to start writing about one of my favorite automotive subjects: the junkyard. Before I'd refined my system for documenting discarded vehicles, however, I shot a lot of boneyard photos that never got used. For today's Junkyard Gem, I have four shots from early 2007 of one of the rarest turbocharged machines of the 1980s: the Chevrolet Turbo Sprint. The Chevrolet Sprint was really a rebadged Suzuki Cultus, from the pre-Geo era when General Motors sold the Isuzu Gemini as the Chevrolet Spectrum, the Daewoo LeMans as the Pontiac LeMans and the Toyota Corolla as the Chevrolet Nova (soon enough, the Spectrum became a Geo, and the Nova became the Prizm). The second-generation Cultus appeared in 1988, becoming the Geo Metro on our shores the following year. The Turbo Sprint was available for just the last two years of the Sprint's 1985-1988 American sales run, and it appears that just a couple of thousand were sold; if I'd known at the time just how rare they were, I'd have shot more photos of this one at the now-defunct Hayward Pick Your Part. The turbocharged 993cc three-cylinder produced 70 horsepower, 22 better than the naturally-aspirated version. Since the Turbo Sprint weighed just 1,620 pounds (that's about 500 pounds lighter than a barely more powerful '22 Mitsusbishi Mirage), it was plenty of fun to drive. For 1988, the regular Sprint hatchback cost $6,380 while the Turbo Sprint listed at $8,240 (that's about $15,375 and $19,855 today, respectively). Believe it or not, a Turbo Sprint actually raced in the 24 Hours of Lemons 10 years ago, though it didn't end well. This ad is for the regular Cultus, not the Cultus Turbo, but the screaming guitars sound reasonably turbocharged. For the most part, Chevy Sprint marketing was all about cheap purchase price and stingy fuel economy… at a time when gasoline prices were cratering. Related Video:

GM adds 1,200 jobs at Detroit-Hamtramck plant

General Motors is making a big move at its Hamtramck, MI, factory, announcing it will add a second shift and hire over 1,200 workers within the next several months. It's expected that by early 2016, the factory will employ over 2,800 workers to build the Chevrolet Volt, Impala, Malibu, Cadillac ELR, and by early next year, the new CT6. According to GM Hamtramck spokesperson Courtney Zemke, 40 of the 1,200 positions are for salaried employees, while the remainder will be hourly positions. As for where these employees will go, positions are being made available across the factory, so GM isn't focusing on any particular area for its new hires. It's a similar story behind the hiring surge itself. GM said in its press release that the "second shift is necessary to meet forecasted market demand," a position Zemke reiterated. It's a matter of demand across the plant's portfolio, rather than any one particular product seriously outstripping supply. Naturally, the United Auto Workers is happy with the move. "The workforce at Detroit-Hamtramck is second to none," UAW Local 22 Shop Chairman Don LaForest said in the attached release. "We appreciate the opportunity to expand our UAW-GM family." Hiring is going on now, with the second shift slated to get underway in early 2016. GM's Detroit-Hamtramck Assembly to Add Second Shift and More Than 1,200 Jobs Plant will nearly double its workforce by early 2016 2015-10-22 DETROIT – General Motors is nearly doubling its workforce at Detroit-Hamtramck Assembly by adding a second shift and more than 1,200 hourly and salaried jobs. The addition of a second shift will increase the plant's workforce to approximately 2,800 people when hiring is completed. The second shift is necessary to meet forecasted market demand for the five cars produced at Detroit-Hamtramck. "This is the result of the award-winning vehicles Detroit-Hamtramck produces and the confidence GM has in our team to build world-class quality for our customers," said Plant Manager Gary West. Second shift hiring is underway, and the shift is scheduled to begin operations in early 2016. "The workforce at Detroit-Hamtramck is second to none," said UAW Local 22 Shop Chairman Don LaForest. "We appreciate the opportunity to expand our UAW-GM family." The 4.1 million-square-foot Detroit-Hamtramck Assembly opened in 1985. GM has invested $1 billion in the plant over the last six years, making it one of the company's most-agile manufacturing facilities in North America.