2008 Orange Automatic V8 Leather Navigation Miles:30k Selective Ride Heads Up on 2040-cars

Auto blog

2018 Ford Expedition vs other big SUVs: How it compares on paper

With our Alex Kierstein rightly impressed in his first-drive review of the new 2018 Ford Expedition, we decided to dig a little deeper into the numbers, and we came up with the spreadsheet below to highlight how the new 2018 Expedition compares on paper to its main full-size SUV competitors: the 2018 Chevy Tahoe and Suburban (and therefore the 2018 GMC Yukon), 2018 Toyota Sequoia and 2018 Nissan Armada. We also threw in the new, even bigger 2018 Chevrolet Traverse since, as you'll see, its massive dimensions should put it on the radar for anyone who needs loads of passenger and cargo space but doesn't care as much about towing. A few notes about the chart above. First, the 6.2-liter V8 that's included with the new-for-2018 Tahoe RST trim level is the standard engine on the GMC Yukon Denali. You can apply most of the Tahoe's numbers to the entire Yukon and Yukon XL lineup. Second, though we highlighted categories where the Traverse led, we also highlighted the runner-up full-size SUV, since this was ultimately about that segment. Traverse numbers are broadly applicable to the new Buick Enclave. Related Video: Chevrolet Ford GMC Nissan Toyota SUV Comparison consumer ford expedition gmc yukon chevy traverse toyota sequoia nissan armada chevrolet tahoe ford expedition max

Next-gen Chevy Volt will get 1.5-liter, four-cylinder engine

As General Motors gets ready to unveil the new Chevy Volt at the Detroit Auto Show in January, it's starting to reveal a few more details about the updated plug-in hybrid. Today should be fruitful on that front, thanks to an event GM is hosting today that focuses on the new Volt, and we've just had the first bit of new: a bigger engine is coming. Since the beginning, the Volt has used a 1.4-liter, four-cylinder engine as a range extender when the battery runs dry. The second-generation model will instead get a slightly larger 1.5-liter, four-cylinder engine that will be built in Flint, MI. That's a step up from the various engines that have been a part of the 2016 Volt's rumored mills, everything from a 1.0-liter or 1.2-liter three-cylinder to a 2.0-liter turbo. The confirmation about the new 1.5-liter powerplant was found in Automotive News, where we also heard again that GM is going to start building the new Volt's electric drive unit in Detroit, moving production up from Mexico. We will have more information on the 2016 Chevy Volt later today.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck