1963 Chevrolet Corvette on 2040-cars
Islamorada, Florida, United States
Fully numbers matching frame off restoration. L75 327 300 HP, Borg Warner T-10 4 speed, Power brakes, Power
windows, Highway 3.08 Positraction rear, Original AM/FM radio included with an aftermarket original appearance blue
tooth AM/FM installed, tool storage under driver seat, articulating drivers seat and telescopic steering. Correct
Silver Blue exterior w/white convertible top, Dark blue interior. This is an early build C-2 with all mechanical
engine and suspension components either rebuilt or replaced. The original broach marks appear on the block stamping
pad with the correct date/engine code and VIN. This car will pass any originality inspection by a Corvette expert.
The frame is original with VIN stamps and absolutely no rust, cuts or after factory welds. The 1963 frame is
specific to the 1963 build year. This car has been listed in a C2 registry since the early 70's.
Chevrolet Corvette for Sale
- 1967 chevrolet corvette(US $16,800.00)
- 1963 chevrolet corvette(US $23,726.00)
- 1963 chevrolet corvette(US $23,800.00)
- 1969 chevrolet corvette stingray(US $16,800.00)
- 1967 chevrolet corvette(US $27,650.00)
- 1963 chevrolet corvette roadster(US $31,570.00)
Auto Services in Florida
Yogi`s Tire Shop Inc ★★★★★
Window Graphics ★★★★★
West Palm Beach Kia ★★★★★
Wekiva Auto Body ★★★★★
Value Tire Royal Palm Beach ★★★★★
Valu Auto Care Center ★★★★★
Auto blog
GM recalls full-size truck, SUVs and vans over faulty shifter mechanism
Mon, 07 Jan 2013Twelve different General Motors vehicles from the 2013 model year, up to 54,686 units in total, are being recalled over two potential issues with their steering columns. The models in question, all full-size trucks, SUVs or vans, are the: Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Express, Silverado, Suburban, Tahoe, and GMC Savana, Sierra, Yukon and Yukon XL.
The affected vehicles were built with a fractured parking lock cable or "a malformed steering column lock actuator gear in the lock module assembly." As a consequence, they could shift out of park without the brake pedal being applied or with the key removed or in the off position.
A bulletin from the National Highway Traffic Safety Administration indicates that the recall should begin on January 17. GM will notify owners, at which time they can take their vehicles to their dealers for repair free of charge. Have a look at the bulletin below for more information.
Motor Trend puts Chevy Camaro Z28 and Porsche 911 GT3 Head 2 Head
Mon, Dec 29 2014Motor Trend admits, "This is an unfair comparison." But that doesn't make it any less fun to watch when they pit a Camaro Z/28 against the Porsche 911 GT3. The former has a 7.0-liter V8 with 505 horsepower and 481 pound-feet of torque shifted through a six-speed manual. The latter has a 3.8-liter flat-six with 475 hp and 324 lb-ft shifted through a seven-speed dual-clutch transmission. Yet those are only the little disparities – the big disparities are mass and money: the Camaro weighs 3,882 pounds and costs $76,150 as-tested, the Porsche weighs 3,267 pounds and costs $145,785. But they're both about hardcore performance, so MT takes them out on the street, to the drag strip, to the parking lot for figure eights and a skidpad test, and finally to Big Willow for Randy Pobst to give his professional assessment. Remember when a lotta people spent a lotta time debating Pirates vs. Ninjas? This is like that, only it's the "haul-ass good-time car" vs. the "track surgeon." Enjoy the debate in the video.
UAW to vote on strike at Kentucky Corvette plant
Tue, 08 Apr 2014The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."