2009 Chevrolet Cobalt 4dr Sdn Lt W/1lt Look At The Miles We Finance on 2040-cars

Auto blog

Next Corvette ZR1 to get 700 horsepower?

Word has it General Motors may offer as much as 700 horsepower in the C7 Corvette ZR1. Motor Trend reports the next Corvette Z06 will continue to rely on its naturally aspirated 7.0-liter V8 engine for thrust, but the lump will deliver substantially more power. How much more? MT says the engine could deliver up to 600 ponies. That's a jump of 95 horsepower over the current Z06, though no figures have been finalized as of yet. Right now, GM is reportedly waiting to see what sort of grunt it can glean from the next ZR1.
The automaker has already made it clear it will resurrect the LT5 name for the new supercharged V8, and if GM is already pulling 600 from the Z06, the big dog ZR1 would theoretically offer 700 horsepower. Either way, the range-topping Corvette will be suitably insulated from its less potent siblings. Stay tuned. We aren't likely to see the Z06 for at least a year, with the ZR1 trailing along at some point there after.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

CNG-powered Chevy Sonic, Cruze headed your way

The value proposition for a Crazy Diamond Performance CNG ride was a little bit better before gas prices took a dive in the past month. Still, the Michigan-based company, which converts some of Chevrolet's compact vehicles to run on compressed natural gas, received approval late last month from the US Environmental Protection Agency (EPA) for two of its conversion models. And CNG is still pretty cheap. Crazy Diamond will start selling CNG versions of both the Chevrolet Cruze and Chevrolet Sonic. The startup will target fleet operators looking to cut both refueling costs and their carbon footprint. CNG can be found in much of the country in the low $2 range, while the average CO2 emissions are about 25 percent less than those of similar gas-powered vehicles. Average gas prices have tumbled by more than 30 cents a gallon in the last month, according to AAA, but they're still at close to $3. The two models will be able to go almost 300 miles on a full tank of CNG. Crazy Diamond said this summer that it would start selling converted a CNG-powered Cruze that delivers 130 horsepower for as low as $26,000. The turbocharged version goes for about $28,000. Take a look at Crazy Diamond Performance's celebratory press release below. Crazy Diamond Performance recieves EPA approval on its CNG Cruze and Sonic CDP receives EPA approval for its Mono-Fuel CNG Cruze and Sonic. Shelby Township, Michigan, October 30, 2014– Crazy Diamond Performance (CDP) receives EPA approval on its Mono-Fuel Compressed Natural Gas (CNG) Chevrolet Cruze and Chevrolet Sonic. Crazy Diamond Performance has received EPA approval on two new mono-fuel small passenger vehicles, the CNG Chevrolet Cruze and CNG Chevrolet Sonic. These new mono-fuel CNG platforms are the first of a series of small and fuel efficient vehicles coming from CDP, where cost, low emissions and reduced fuel consumption is important for not only fleet owners, but to the general public as well. "Soon to be available, are the 1.8L and 1.4L Cruze and Sonic CNG retrofit systems. These two vehicles represent a change in the status quo, with an OEM level integration of the fuel system and its components" states Michelle Fern, Executive Vice President CDP Inc. These vehicles provide flexibility for fleets looking to purchase a domestic small mono-fuel passenger sedan, but have not had an option until now. There are significant emissions benefits over its gasoline counterpart, with an average reduction in Carbon Dioxide (CO2) of 25%.