1968 Ss 396 Chevelle, Real 138 Car, Factory Front Powered Disk Brakes on 2040-cars

Auto blog

GM recalling 1.4 million older vehicles for oil leak fire risk

General Motors is recalling 1,411,332 older vehicles with its 3.8-liter V6 yet again due to a fire risk. Specifically, there are 1,283,340 of them in the US, and the affected models are the: 1997-2004 Pontiac Grand Prix 2000-2004 Chevrolet Impala 1998-1999 Chevrolet Lumina 1998-2004 Chevrolet Monte Carlo 1998-1999 Oldsmobile Intrigue 1997- 2004 Buick Regal The fault with these vehicles is that oil can drip onto the hot exhaust manifold during hard braking, which can potentially cause of fire. In the last six years, there have 19 reported minor injuries from this problem but no crashes or fatalities, according to the company. Spokesperson Alan Adler also told Autoblog: "GM has reports of 1,345 fires in vehicles that were repaired under two previous recalls for this issue." At this time, GM is still developing a remedy for the problem. According to Adler, the company advised owners to park these vehicles outside for the previous recalls. "The cars can be safely driven. In cases where a customer reported an engine fire while driving, smoke was reported, which would be an indication of a malfunction," he said. This is GM's fourth recall for this problem since 2008, according to The Detroit News. At one point it was believed that aging valve cover gaskets allowed the oil to leak out and drip onto the manifold. A campaign in 2009 covered nearly 1.5 million of these models through the 2003 model year for the same issue. At the time, dealers installed new spark plug wire retainers as a fix. Related Video: GM Statement: General Motors is recalling 1,283,340 older sedans and coupes in the U.S. from the 1997 to 2004 model years because drops of oil may be deposited on the hot exhaust manifold through hard braking, which can cause engine compartment fires. GM is working on a remedy. The company is aware of post-repair fires in some vehicles but no crashes or fatalities. There have been 19 reported minor injuries over the last six years. These vehicles with 3.8-liter V6 3800 engines are affected: 1997-2004 Pontiac Grand Prix, 2000-2004 Chevrolet Impala, 1998-1999 Chevrolet Lumina and 1998-2004 Chevrolet Monte Carlo, 1998-1999 Oldsmobile Intrigue and 1997-2004 Buick Regal. Including Canada, Mexico and exports, the total population is 1,411,332.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM veteran Bryan Nesbitt tapped to head Buick design

General Motors styling veteran Bryan Nesbitt (pictured above) took over a new role on Monday as executive director of global Buick design and global architectures. Andrew Smith, who previously did that job and also coordinated the look for Cadillac, has remained in charge of the pen at Caddy with this shift. Nesbitt rose to prominence when he designed the Chrysler PT Cruiser, according to Automotive News. He joined GM in 2001 and has been there ever since in multiple high-level roles. In 2007, he was appointed vice president of design for North America and was later briefly general manager of Cadillac in 2009-2010. Nesbitt took over as the vice president of GM's international operations design in China in 2011. This shuffle also moves Ken Parkinson, currently styling boss for Chevrolet trucks, to China as design vice president there. In addition, John Cafaro becomes the person in charge of the look for Chevy globally, rather than previously splitting that role between cars and trucks with Parkinson. GM Global Design Leadership Changes – effective June 1, 2015. Bryan Nesbitt, Design Vice President, GM China will repatriate to North America and assume the position of Executive Director, Global Buick and Global Architectures. He will be located in Warren, MI. Bryan will be the design Champion for Buick in the US and China. Ken Parkinson, Executive Director, Global Chevrolet Trucks and Global Architecture will assume the position of Design Vice President, GM China. He will be based in Shanghai, China. Andrew Smith, Executive Director, Global Cadillac and Buick Design will assume the position of Executive Director, Global Cadillac. He will continue to be the design Champion for the Cadillac brand. In addition, he will continue to lead the Global Color & Trim team. He will be based in Warren, Michigan. John Cafaro, Executive Director, Global Chevrolet Cars will assume the position of Executive Director, Global Chevrolet. He will be the design Champion for Chevrolet. In addition, John will lead the exterior components and accessories team. He will continue to be based in Warren, MI. The roles and responsibilities of Helen Emsley, Mark Adams, Carlos Barba, Clay Dean, Michael Simcoe, and Teckla Rhoades remain the same. Related Video: The video meant to be presented here is no longer available. Sorry for the inconvenience.