1967 Chevrolet Chevelle on 2040-cars

Auto blog

'84 MotorWeek Cherokee, Bronco and Blazer comparison indulges your SUV nostalgia

These days, truck-based, full-frame SUVs are somewhat of a rarity on the auto landscape due to the rapid rise in popularity of easier-driving, car-based crossovers. Although, without the gradually building popularity of these chunky, high-riding vehicles decades ago, it's unlikely that America's roads would be filled with so many CUVs today. In its latest dig into the archives, MotorWeek has found a 1984 comparison test of a trio of these early Sport Utility Wagons, as long-time host John Davis called them, that helped get acceptance of this segment going. This is a red, white and blue test of the SUVs from American automakers at the time and pits the Chevrolet Blazer, Ford Bronco and Jeep Cherokee (specifically in Wagoneer guise) against each other. Driving manners and interior usability are considered in the evaluation, but Motorweek actually takes these vehicles off road, too. Among the bigger revelations is the improvement in on-road ability in the past 30 years. While specific 0-60 times aren't given, all three models take around 10 seconds just to get to around 50 miles per hour in the 500-feet on-ramp acceleration test. Check out this clip to see just how far this segment has progressed in the past three decades or just get a blast of nostalgia from these now vintage models. News Source: MotorWeek via YouTube Chevrolet Ford Jeep SUV Off-Road Vehicles Classics Videos Ford Bronco chevy blazer

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Leaked GM document shows GMC Sierra I6 diesel is more powerful than F-150's

GM told us earlier this year that the 2019 GMC Sierra would be getting a 3.0-liter I6 diesel option, but it never mentioned power or fuel economy figures. Hold the phone though, because a leaked GM Canada document just showed up online that lists out the details we've been waiting for. Originally published by TFL Truck, the 3.0-liter oil-burner supposedly makes 282 horsepower and 450 pound-feet of torque. For those who are counting, that's more than the Ford F-150's 250 horsepower and 440 pound-feet from its 3.0-liter diesel. It soundly bests the 240 horsepower and 420 pound-feet of torque from Ram's 3.0-liter diesel as well. Fuel economy is another story, though. The promotional material states that it will get 28 mpg on the highway, which is 2 mpg short of the F-150's 30 mpg — mind you, it's only capable of that magical 30 mpg figure in rear-wheel drive form. There's another caveat here, too; these are numbers for Canada, so they're not exactly finalized EPA figures. However, we wouldn't expect drastic differences between the two when the American numbers come out. The leaked documents also state the diesel Sierra will be capable of towing 7,800 pounds. That number seems remarkably low when compared to the F-150, which can tow up to 11,400 pounds with its diesel. Extra power and torque would have us assume that GM could get even better numbers than Ford, so we're going to hold our final judgment for official word. A 10-speed automatic will do the shifting on the diesel, just like on the 6.2-liter V8. Since the Chevy Silverado is also expected to get this engine, we can assume the figures would be almost, if not identical, to those we see here. We recently drove the 2019 Sierra and Silverado without the diesel engines, so go check those reviews out if you'd like to know more of our thoughts on the redesigned GM trucks. Related video: