1969 Chevrolet Camaro on 2040-cars

Auto blog

Camaro SS facelift and dune-riding the new Mercedes-Benz GLS | Autoblog Podcast #579

In this week's Autoblog Podcast, Editor-in-Chief Greg Migliore is joined by Road Test Editor Reese Counts and Associate Editor Joel Stocksdale. First, they talk about the newly refreshed Chevy Camaro SS. Then they dish on the cars they've been driving, including the Lexus UX, Lexus GS F and Volvo V90, as well as riding in the new Mercedes-Benz GLS. After that, they ask the question, how many AMG cars is too many? Finally they turn to car buying, and suggest potential vehicles for a shopper on Reddit for the "Spend My Money" segment. Autoblog Podcast #579 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Rundown 2020 Camaro SS facelift Cars we're driving: 2019 Lexus UX 2019 Lexus GS F 2019 Volvo V90 Cross Country 2020 Mercedes-Benz GLS ride How many AMGs is too many? Spend My Money Feedback Email – Podcast@Autoblog.com Review the show on iTunes Related Video:

GM recalling nearly 4,000 vehicles over airbag concerns

Four different General Motors vehicles from the 2012 model year are being recalled over a potential airbag issue. The driver's side airbag shorting bar in the 2012 Buick Verano and 2012 Chevrolet Camaro, Cruze and Sonic might make contact with the airbag terminals, even during a crash. If so, the airbag won't deploy when it should, possibly increasing injury to the driver.
The recall is expected to begin on February 13 for the 3,896 units that might be affected. GM will notify owners who can then take their vehicles to dealers to have the airbag coil replaced. A bulletin from the National Highway Traffic Safety Administration below has more info.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck