1997 Chevy 116k Turbo Diesel 4x4 No Reserve Auto 6.5 Liter K3500 1 Ton Truck Run on 2040-cars

Auto blog

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

Experimental mid-engine XP-819 Corvette going up for auction

It seems to be commonplace that when a new Corvette is in development, rumors swirl about a possible mid-engine layout. As is the case of Chevy's most recent C7 Corvette, these rumors never pan out.
In any case, the idea for a 'Vette with an engine mounted behind the driver can probably all be traced back to a single car, the 1964 XP-819 prototype. Built as an "engineering exercise" back in 1964, the prototype was designed with a rear-mounted engine. History tells us that the idea of a rear-engine Corvette fizzled, and the XP-819 was eventually cut up into pieces and stored at a shop in Daytona Beach, FL.
After sitting for untold years, a restoration project started on the car, and while it isn't yet fully completed, the current owner of the car, Mid America Motorworks, will have the car on display at the 2013 Amelia Island Concours d'Elegance as a "driveable chassis" with hopes of having a fully completed car ready to bring to next year's show.

GM 6.2L V8 claims most powerful light-duty truck engine title

General Motors has officially captured the horsepower crown for mainstream pickup trucks with its 6.2-liter V8. The big mill, available in both the Chevrolet Silverado and GMC Sierra, comes to market with 420 horsepower and 460 pound-feet of torque, handily outdoing its two cross-town competitors, Ram (5.7-liter V8, 395 ponies and 407 lb-ft) and Ford (6.2-liter V8, 411 hp and 434 lb-ft).
The new GM 6.2 will take a bit of an investment, though. Those that want the extra thrust will need to go with either the LTZ or High Country trims from the Chevy, or the SLT and Denali trims from GMC, which are the two highest trim levels for the respective vehicles. Trim levels aside, if you're in the business of towing, GM has you covered. Optioned with the 6.2-liter V8 and the Max Trailering Package, owners will be able to pull 12,000 pounds, a hugely impressive figure.
We still aren't certain as to what sort of economy the new engine will get, but it'll probably be a bad bet for the fuel conscious. As for availability, expect to see the 6.2-liter trucks in showrooms later in the fall.