Find or Sell Used Cars, Trucks, and SUVs in USA

91 Chevy Gmc Solid Axle Converted Ifs 4x4 Truck Tbi 4sp 205 on 2040-cars

US $1,500.00
Year:1991 Mileage:237000
Location:

Reinbeck, Iowa, United States

Reinbeck, Iowa, United States
Advertising:

 This is a project truck that I have lost interest in, my loss is your gain.It does run and drive but I have not had on highway, just around town.
1991 chevy 2500 with chevy(not ford front) 3.23 geared axles swapped in
Wheelbase shortened to 131.5- uses factory standard  cab long box drive shafts
Powered by 350tbi into a hydraulic bellhousing in front of sm465 4sp with 205 case(was an auto truck originally)
New master and slave for clutch,new GM flywheel and aftermarket clutch.
Rear disc brake conversion installed including willwood proportioning valve and a line lock for parking brake
New steering parts for crossover steering.
33x12.50 tires on steel wheels
Has short bucket seats in the front.
Dash says 237k but only 130ish on tranny/case not sure if original engine or not runs good though.



Box is just tacked together, will need to be finished.
Interior is missing carpet and rear seat/plastic panels in rear.Also a couple of dash vents are gone.
Truck is rusty as you can see but will include new patch panels.
Needs a front drive shaft as well, the one that I had purchased for it was out of an auto truck and therefor too long.
As I have said this is a project but all of the hard work is already done.

Also included with truck will be a set of 4.56 geared chevy axles,brand new rockers and cab corners, rear bumper,spare doors, gas door for box and I'm pretty sure I have a tail light to fix the  one that is broken,also have other misc parts to go with, may find some other parts too while I dig around.

I hope I am not forgetting anything but we all make mistakes, any questions just ask.
Clear title in hand.
Winning bidder to pay $200 deposit via paypal within 2 days of auction close.Remainder in cash upon pickup.
WILL NOT SHIP!buyer is responsible for vehicle pickup!Possible delivery in 500 mile radius for $1 a mile  CONTACT ME BEFORE BIDDING if you will need this delivered
Truck is for sale locally so I reserve the right to end auction at any time.
Good luck and happy bidding!

Auto Services in Iowa

Tony`s Tire Service ★★★★★

Auto Repair & Service, Tire Dealers, Transport Trailers
Address: 2207 Vail Ave, Popejoy
Phone: (866) 595-6470

Scotty`s Body Shop ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Customizing
Address: 1430 Linden St, Windsor-Heights
Phone: (515) 505-8122

Schuling Hitch Company ★★★★★

Automobile Parts & Supplies, Trailer Hitches, Automobile Accessories
Address: 5067 NW 2nd St, Mitchellville
Phone: (515) 218-1323

Rod`s Automotive and Tire Clinic Inc ★★★★★

Auto Repair & Service, Tire Dealers
Address: 104 E Main St, New-London
Phone: (319) 367-9105

R J Automotive ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc
Address: 900 Highway 965 NE, Oxford
Phone: (319) 665-2636

Pat McGrath Dodge Country ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Body Repairing & Painting
Address: 4610 Center Point Rd NE, Robins
Phone: (319) 393-4610

Auto blog

GM patent reveals new two-stage turbocharger

Fri, Jun 24 2016

Modern turbochargers may be some of the best ever made, but performance is something that engineers are always trying to improve. According to GM Inside News, General Motors (GM) is hoping to alleviate some of the negative aspects of a two-stage turbocharger setup with a newly-patented design. The patent, that was filed on May 19, 2016, reveals a clever bypass system that allows the engine, a four-cylinder unit, to optimize both the low-pressure and high-pressure inlets for its respective functions. According to the filing, a conventional two-stage turbocharger setup is engineered to allow both turbines to operate simultaneously at low and mid engine speeds. At high engine speeds, only the low-pressure turbine works. The setup can't isolate either the low or high pressure side, which can impair low-end performance. GM's new two-stage turbocharger setup looks to eliminate this by linking the high-pressure turbo to the exhaust manifold through the high-pressure inlet duct. The low-pressure turbo is attached to the high-pressure turbo by a low-pressure inlet duct, which is linked to a connecting channel. A single actuator that is housed in the exhaust manifold creates a bypass that can opens the high-pressure inlet or close the connecting channel. Depending on what the engine load and speed is, the ECU guides the actuator—a single rotating spindle with discs corresponding to flanges on the high and low pressure sides—to isolate one of the two turbos. Isolating the turbos allow the respective inlets to be engineered for the best possible fluid dynamic performance. The setup should increase performance and decrease lag. There's no word on what car this setup will make an appearance on, but it will most likely be used in premium vehicles before trickling down to the rest of GM's vehicles. Related Video: News Source: GM Inside News, AutoGuide via GM Authority Cadillac Chevrolet GM Technology Sedan turbo patent engine turbocharging

Car Club USA: Louisiana Mudfest

Tue, Jun 16 2015

There's nothing quite like mudding. Big tires, huge power, and crazy-wild gearheads that like to throw down on a mud pit almost as much as a thirty rack of Coors. In the latest, and some might argue greatest yet episode of Car Club USA, we head to Louisiana to throw some dirt at Mudfest. As Louisiana's one and only Mouth of the South puts it, "If you don't mud ride... go to Texas I guess." Joining The Mouth and friendly rivals The Most Hated Mud Sluts, we dive in. Beyond the obvious V8 blasting and tractor-tire spinning, those who know best describe Mudfest as, "Good cooking, good friends, good fun, and a lot of partying." It's a motorsport spectacle unlike any you're likely to find up North or out West, though no less impressive to behold. Follow along with the fun, the impromptu drag racing, the trash talking, and the mechanical madness. And find out why, at Mudfest, "if we don't tear it up, we ain't done it right." Each Car Club USA episode features a different car club or event from across the US, where passionate owner communities gather to share automotive experiences and embark on incredible adventures. From Main Street cruises to off-road trails, catch all the latest car club activity on Autoblog. Chevrolet Ford Jeep RAM Truck Off-Road Vehicles Car Club USA Videos autoblog black

Next-gen GM SUVs caught wearing new boxy bodies [w/video]

Wed, 15 May 2013

We recently drove the brand-new 2014 Chevrolet Silverado and found it to be vastly improved compared to the outgoing model. And now that The General's pickup trucks have been squared away, it's time to focus our attention onto their passenger-friendly companions, the Chevrolet Tahoe and GMC Yukon (above).
Our spy photographers have passed along a huge smattering of photos (and a video), showing the new SUVs out testing. Both the short- and long-wheelbase models were spied, and while the overall shape of the vehicles hasn't changed all that much, we expect the updates to be substantial. In addition to new powertrain options, like GM's new small-block V8, we expect the interiors of both SUVs to get massive makeovers, providing better materials throughout their cabins and quieter, more refined environments. We even hear that some trick new suspension developments may be in store for upper-end models.
Visually, these spy shots allow us to see a couple of new details on the SUVs' front and rear fascias, including LED running lamps on the Yukon and some interesting LED taillamp treatments. Of course, the obvious third party missing from this set of photos is the Cadillac Escalade, but as we reported earlier, GM is working to further differentiate the 'Slade from the rest of the fullsize SUV lineup, and is working to make the new model "much less ostentatious."