Big Bad Beautiful 1982 Chev on 2040-cars

Auto blog

NHTSA closes 4-year GM investigation, issues common sense advisory [w/video]

Since January 2011, the National Highway Traffic Safety Administration has been investigating a possible problem with corroding brake lines in General Motors' GMT800-platform models, like the Chevrolet Silverado and Suburban and GMC Sierra, in states with salt on their roads in the winter. However, as opposed to launching a full recall of millions of vehicles, the government is issuing a common-sense safety advisory to all drivers in snowy states to keep their vehicle's undercarriage clean. It even has a video explaining things. "Older-model vehicles, often driven in harsh conditions, are subject to corrosion over long periods of time, and we need owners to be vigilant about ensuring they, their passengers, and others on the roads are safe," said NHTSA Administrator Mark Rosekind in the announcement of the end of the investigation. The agency was clear in its report that "brake line corrosion seen in the GM vehicles was not unique," and the government "has not identified a defect that would initiate a recall order." Instead NHTSA is advising drivers, especially those of vehicles from before 2007, to wash their vehicle's undercarriage in the winter and spring to remove salt or other de-icing chemicals. It also recommends regular checks by a mechanic to make sure everything is in proper order. According to the investigation documents, for just the GMT800 platform models, NHTSA found 3,645 complaints of brake line corrosion, which included allegations of 107 crashes and 40 injuries. The issue was found to be more common in vehicles over 10 years old. GM has released a statement (embedded below) that the company "supports the consumer advisory from NHTSA urging regular maintenance and care of brake lines on older vehicles." NHTSA Closes Investigation into Brake-Line Failures NHTSA 13-15 Thursday, April 9, 2015 Agency issues safety advisory on preventing undercarriage corrosion WASHINGTON – The Department of Transportation's National Highway Traffic Safety Administration (NHTSA) today issued a Safety Advisory and consumer video encouraging owners of model year 2007 and older trucks, SUVs and passenger cars to inspect brake lines and thoroughly wash the underside of their vehicles to remove corrosive salt after the long winter in order to prevent brake-line failures that increase the risk of a crash.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Next-gen Chevy Cruze caught cruising in the cold

Spy photographers have caught what looks like the next-generation Chevrolet Cruze out on snow patrol. The camo could be tricking our eyes, but it look like it has an even tidier, more rounded front end and even lower fenders in relation to the top of the hood. And either a chunk of camo has been wedged between the side mirrors and the doors, or the mirrors are up for revision, too.
The door handles have been moved up the side of the car, leading the way to a rear end that grows a bit in length. If the rumors are true, the coming second-generation Cruze sits on the new D2XX platform that will replace the Delta and Theta platforms at General Motors. A global architecture, the Cruze will be the first to get it, but it will underpin everything from next Chevrolet Volt to the Equinox and could be responsible for 2.5 million units by 2018. The next Cruze is expected to begin production in GM's Lordstown, Ohio plant in the third quarter of 2014.