1967 Chevy C-10 Stepside Sbc Engine Runs Great P/s P/b Heater Good Tires Look on 2040-cars

Auto blog

Junkyard Gem: 1986 Chevrolet Sprint Plus

General Motors sold second- and third-generation Suzuki Cultuses with Geo or Chevrolet Metro badging in the United States from 1989 through 2001 model years, and we've all seen plenty of those cars on the street over the years. The first-generation Cultus was sold here as well, with Chevrolet Sprint badges, and I've found a rare example of the Sprint five-door hatchback in a Northern California car graveyard. The Chevy Sprint first appeared on the West Coast as a 1985 model, then became available everywhere in the United States for the 1986 through 1988 model years (in Canada, it was sold as the Pontiac Firefly). It was available here as a hatchback with three or five doors; for 1986 only, the five-door was badged as the Sprint Plus. Soon enough, The General would be selling many more Asian-built cars with Detroit badges here. Isuzu I-Marks were sold as Chevrolet/Geo Spectrums starting in the 1986 model year, while Daewoo provided the Pontiac LeMans two years later. Under the hood, a 1.0-liter three-cylinder rated at 48 horsepower. The five-door Sprint cost $5,580 in 1986, which was $200 more than the three-door (those prices would be $15,445 and $14,891 in 2023 dollars). I've documented seven discarded Sprints prior to this one (including an extremely rare Turbo Sprint), and all of them were three-doors; we can assume that price was the most important factor for Sprint buyers. Gasoline prices were crashing hard during the middle 1980s, but memories of gas lines and odd-even-day fuel rationing from 1979 remained strong. What cars competed with the '86 Sprint on sticker price? Well, there was no way to undercut the hilariously affordable (and terrible) Yugo GV, which cost $3,990. The much bigger (but still pretty bad) Hyundai Excel listed at $4,995, while Toyota would sell you a sturdy (but zero-fun) Tercel starting at $5,448. Even the wretched Chevy Chevette — yes, it was still available in 1986 — cost $5,645. The original buyer of this car was willing to shell out an extra $395 to get an automatic instead of the base five-speed manual. That's about $1,093 in today's money. This car must have been slow. By the end, the doors were held shut with duct tape, but it still stayed alive until age 37. 53 miles per gallon on the highway! It does everything. The camels of the highway.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2014 Chevrolet Corvette Stingray Convertible is a Swiss hit

We've just received an early peek at the 2014 Chevrolet Corvette Stingray Convertible here at the Geneva Motor Show. General Motors was kind enough to let us attend the final dress-rehearsal for its press conference scheduled for tomorrow's opening media day, and we've come away with a good look at the droptop C7 in person.
In the metal, the new Corvette Convertible seems somehow less avant-garde than the Coupe, even in Z51 Performance Package guise. That's not necessarily a bad thing - more of an observation. That initial impression may be because the C7's new greenhouse is one of its most prominent departures from Corvettes past. While we didn't get to see the top erected, there's no rear side window in the stock images that Chevy has already released, suggesting the C7 convertible's profile will look a lot like its C6 predecessor. And with the new power tonneau cover in place, there are also no rear ducts that come as part of the Z51 package (they've been moved under the car).
As with its predecessor, the tonneau is a handsome double-bubble piece, and the body-color "waterfall" element into the cabin between the seats has made it to the new model as well. Thus, the overall look with the top down should be a bit more familiar to prior-gen C6 owners - if you're one of those put off by the C7's new shape, you'll probably appreciate the convertible bodystyle more than the coupe.