1963 Chevy Stepside on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]

UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.

What if the mid-engine Corvette is really a Cadillac?

Call me crazy, but I'm not convinced the mid-engine Corvette is the next Corvette. The rumor is strong, yes. And, contrary to some of the comments on our site, Car and Driver - leader of the mid-engine Corvette speculation brigade - has a pretty good record predicting future models. But it's another comment that got me thinking: or maybe it's a Cadillac. There is clearly something mid-engine going on at GM, and I think it makes sense for the car to be a Cadillac. First off, check out how sweet the 2002 Cadillac Cien concept car still looks in the photo above. Second, there are too many holes in the mid-engine Corvette theory. There are too many holes in the mid-engine Corvette theory. The C7 is relatively young in Corvette years, starting production almost three years ago as a 2014 model. Showing a 2019 model at the 2018 North American International Auto Show would kill sales of a strong-selling car before its time. Not to mention it would only mean a short run for the Grand Sport, which was the best-selling version of the previous generation. More stuff doesn't add up. Mid-engine cars are, in general, more expensive. Moving the Vette upmarket leaves a void that the Camaro does not fill. There's not much overlap between Camaro and Corvette customers. Corvette owners are older and enjoy features like a big trunk that holds golf clubs. Mid-engine means less trunk space and alienating a happy, loyal buyer. Also, more than 60 years of history. The Corvette is an icon along the likes of the Porsche 911 and Ford Mustang. I'm not sure the car-buying public wants a Corvette that abandons all previous conventions. And big changes bring uncertainty - I don't think GM would make such a risky bet. Chevrolet could build a mid-engine ZR1, you might say, and keep the other Corvettes front-engine. Yes they could, and it would cost a ton of money. And they still need to fund development of that front-engine car. I highly doubt the corporate accountants would go for that. But a Cadillac? Totally. Cadillac is in the middle of a brand repositioning. GM is throwing money at this effort. A mid-engine halo car is the just the splash the brand needs to shake off the ghosts of Fleetwoods past. And it's already in Cadillac President Johan De Nysschen's playbook. He was in charge of Audi's North America arm when the R8 came out. A Caddy sports car priced above $100,000 isn't that unreasonable when you can already price a CTS-V in that range.