Find or Sell Used Cars, Trucks, and SUVs in USA

1940 Cadillac Fleetwood on 2040-cars

US $14,560.00
Year:1940 Mileage:89034 Color: White /
 Gray
Location:

Tenafly, New Jersey, United States

Tenafly, New Jersey, United States
Advertising:

1940 Cadillac Fleetwood 75 Limousine Body. ONE OF KIND see pictures. You will get lots of attention while driving
this beautiful vehicle. Lots of room. Please feel free to call me for a detailed-honest description of this Classic
automobile.

Auto Services in New Jersey

Williams Custom Tops-Interiors ★★★★★

Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery, Automobile Accessories
Address: 910 Woodbourne Rd, Fieldsboro
Phone: (215) 757-3100

Volkswagon of Langhorne ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 1862 E Lincoln Hwy, Pennington
Phone: (215) 741-4100

Vip Honda Honda Automobiles ★★★★★

New Car Dealers
Address: 542 Somerset St, Fanwood
Phone: (908) 753-6071

Tri State Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 15511 Liberty Ave, West-New-York
Phone: (718) 206-0143

Solveri Collision Center ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 2300 Route 88, Asbury-Park
Phone: (732) 202-7448

Scotts Auto Service ★★★★★

Auto Repair & Service
Address: 161 Kinderkamack Rd, Haworth
Phone: (201) 391-3433

Auto blog

Cadillac XT3 caught covered in copious camouflage

Wed, Feb 15 2017

While a bit difficult to tell thanks to the impressive camouflage used, what we're looking at here is likely the upcoming Cadillac XT3. There are a few details that stand out to lend credence to this prediction. There are a handful of sharp angles scattered throughout that are in line with Cadillac's modern design language. Specifically in the LED running lights and on the side mirrors. The rear profile also is reminiscent of the current, and slightly larger XT5. The rear lights extend into the D-pillars, which would match the current Escalade. We get a pretty clear picture of the rear suspension on this XT3. It's clearly an independent rear suspension using coil springs. While General Motors uses independent suspension on some of its crossovers, we can't quite match it to a particular model. We believe that if the XT3 is based on an existing model (which it almost certainly is), the platform and suspension have been substantially modified. The XT3 could use a version of the D2XX platform that underpins the Buick Envision. However, we know from a previous report that the XT3 will likely be built at the factory that produces the Buick LaCrosse and Chevy Malibu. The XT5 uses a modified version of the LaCrosse/Malibu platform, so it's possible the XT3 could use a shorter version of the XT5 chassis. Depending on how small the XT3 ends up being, it might even share a platform with the Chevy Trax and Buick Encore. However, considering their economy car roots and torsion-bar rear suspension, we think that's the least likely. Regardless of what chassis is underneath its crisp bodywork, we expect the XT3 to be released sometime next year. Related Video:

GM executive chief EV engineer says reducing cost of plug-in vehicles is 'huge priority'

Mon, Mar 17 2014

As we know, another major automaker investing heavily in electrified vehicles is General Motors, and it's doing things much differently than rivals BMW, Ford or Nissan. The Chevrolet Volt extended-range EV is a modest seller at its $35,000 sticker price but a huge hit with owners. The Chevy Spark BEV, still in limited availability, puts smiley faces on its owners and drivers. The just-introduced Cadillac ELR, a sharp-looking, fun-driving $76,000 luxocoupe take on the Volt's EREV mechanicals, has admittedly low sales expectations. With this interesting trio in showrooms and much more in the works, the third vehicle electrification leader I collared for an interview at Detroit's North American International Auto Show (see #1 and #2) was Pam Fletcher, GM's executive chief engineer, Electrified Vehicles. ABG: Why do your EREVs need four-cylinder power to extend their range when BMW's i3 makes do with an optional 650 cc two-banger? "We designed [the Volt and the ELR] to go anywhere, any time" - Pam Fletcher PF: I get that question all the time: why not something smaller? You don't really need that much. You use the electric to its ability, then you just need to limp. But we designed those cars to go anywhere, any time, and we don't want their performance to be compromised. If you're driving through the mountains, we don't want you to be crawling up grades, or to be limited on any terrain. So it's optimized to be able to travel literally the biggest grades and mountain roads around the globe at posted speeds. Because what if you can't? Another good reason: when the engine is on, you have to run it wide open throttle, max speed, most of the time. And while we can do a lot with acoustics, and the ELR has active noise cancelation, a small-displacement, low cylinder-count engine at high speed, high load all the time isn't something you want to live with. That's how we came up with the balance we did among the key factors of performance, NVH [noise, vibration and harshness] and range. ABG: Where you go from here? Is the range-extender engine due for an update? PF: We know and love the current Volt, and there is still a lot of acclaim about it, so we think it's a good recipe. But we are heavily in the midst of engineering the next-generation car, which I think everyone will love and be excited about.

Cadillac can't keep up with Escalade demand, can't move its sedans

Wed, Feb 11 2015

No matter how much Cadillac revitalizes its lineup and its image, it seems that all consumers want is the Escalade. In fact, Automotive News reports that General Motors can't keep up with demand for the fullsize luxury SUV, despite sticker prices that start at over $70,000 and approach six figures at the top end of the spectrum. Contrast that with sedans like the ATS and CTS, which are far cheaper but which Cadillac hasn't been able to move fast enough to keep up with production, prompting both the manufacturer and dealers to offer substantial incentives to keep them from piling up. Cadillac had been resisting a price cut of the ATS or CTS, lest it hurt resale values – itself a factor that could explain consumers' reluctance to buy them in the first place – but been offering subsidized leases, discounted financing, rebates and cheaper options. Combined with incentives from individual dealers, according to AN, buyers can be looking at five-figure discounts on buying a new Cadillac sedan. And now, finally, it seems the CTS will indeed get a little bit off its bottom line. Yet GM has been producing the ATS and CTS at rates that their sales can't keep up with. The automaker was forced to idle the plant in Lansing, MI, where it assembles the ATS and CTS for six weeks starting this past December. And since it reopened late in January, it's been reduced to a single shift as dealers try to move the metal they've already got. Meanwhile the plant in Arlington, TX, that produces the Escalade and its Chevy and GMC siblings has been running on overtime, with three shifts throughout the week and even into the weekend to keep up with demand. Profitable as it's been for Cadillac and GM, though, the Escalade does not represent the future of where it wants to take the brand - separating the Escalade as almost a brand unto itself that's been left out of the company's new naming scheme. If only it could make its sedans as successful as its fullsize SUVs, it'll be all set.