Luxury Navigation Rear Entertainment Xm Sunroof Xm Lane Departure Warning on 2040-cars

Auto blog

New Takata problem results in recall of 414 GM vehicles

An airbag-inflator rupture discovered by Takata during testing has resulted in a new recall affecting 414 vehicles from General Motors, including 395 of them in the US. This latest campaign covers 2015 model-year examples of the Buick LaCrosse, Cadillac XTS, Chevrolet Camaro, Equinox, Malibu, and GMC Terrain. There are no reported breaks in any of these vehicles on the road, and the company estimates only one percent of them actually have the faulty parts. According to documents submitted to the National Highway Traffic Safety Administration (as a PDF), one side-airbag inflator failed a cold test at -40 Fahrenheit "releasing high pressure gas and propelling the separated components apart." The supplier told GM about the failure the next day. In these vehicles, the safety device might not only burst but the bag could inflate incorrectly, as well. GM and Takata say that a cause is not yet known, but they are "conducting an investigation." GM will begin notifying affected owners via overnight mail on Oct. 19. Dealers will replace the side airbag modules on all of the affected vehicles with new components outside of the suspect lot. All of the removed parts will also be collected for further study. Takata's faulty front airbag inflators have resulted in a serious scandal for the supplier. Initial figures indicated 34 million US vehicles are need of repair, though more recent figures have knocked that down to 23.4 million bad parts in 19.2 million automobiles. GM was already among the dozen automakers with models to fix, and some of its pickups were affected, along with the Saab 9-2X and Pontiac Vibe. GM Statement: General Motors is recalling 395 cars and crossovers in the U.S. because one of the front seat side air bags inflators may be defective. In the event of a deployment, the air bag's inflator may rupture and the air bag may not properly inflate. The rupture could cause metal fragments to strike the vehicle occupants, potentially resulting in serious injury or death. GM is unaware of any incidents involving vehicles with these components, which were part of a lot in which one inflator failed acceptance testing at the supplier. Dealers will replace the side air bag module or modules in affected vehicles. Including Canada, Mexico and exports, the total population of the recall is 414, GM estimates 1 percent of the recalled vehicles may have the defect.

2016 Hennessey CTS-V is properly ridiculous with 1,000 horsepower

We truly live in a halcyon era of automotive performance with models like the latest Shelby GT350 Mustang and 707-horsepower Challenger Hellcat. And now Hennessey Performance Engineering is bringing something with absolutely obscene power to the world with its tuned 2016 Cadillac CTS-V that packs a ludicrous 1,000 horsepower. The latest CTS-V isn't even on sale yet but should be a powerhouse straight from the factory. Under its carbon fiber hood is a 6.2-liter supercharged LT4 V8 with 640 horsepower and 630 pound-feet of torque that makes the sedan capable of a 200-mile-per-hour top speed. Hennessey's take ditches the blower in favor of two turbos to feed air to the engine. To cope with the extra power, the mill gets upgrades like forged aluminum pistons and forged steel parts for the rods and crankshaft, and transmission upgrades are also necessary to make it all work. Buyers can even spec things like carbon-ceramic brakes and a widebody kit to allow for bigger tires. The crazy numbers are leading to some big performance claims from company founder John Hennessey. "I believe that our 2016 Twin Turbo CTS-V will have a top speed approaching 240 mph," he said in the Caddy's announcement. Hennessey is building just 24 of these 1,000-horsepower sedans for the 2016 model year. However, for those that want to keep the supercharger under the hood, the company is also offering upgrades with 750 hp and 800 hp for the CTS-V too. All of them sound absolutely ridiculous in an utterly fantastic way. 2016 HPE1000 Twin Turbo Cadillac CTS-V Texas Tuner Plans to Build World's Fastest 4-Door Sedan Sealy, Texas-When the next generation Cadillac CTS-V hits the streets later this year, it will have 640+ hp and a top speed of nearly 200 mph. To the team at Hennessey Performance Engineering (HPE), this is a good starting point. The company plans to pick-up where they left off with the last gen CTS-V by producing the world's fastest 4-door sedan: The Hennessey HPE1000 Twin Turbo CTS-V. "A couple of years ago, the State of Texas gave us the opportunity to test one of our specially tuned CTS-Vs – our VR1200 Twin Turbo coupe. It ran 221 mph (356 km/h) on State Highway 130, near the Circuit of the Americas", said company founder, John Hennessey. "It was still pulling on when we ran out of road. I believe that our 2016 Twin Turbo CTS-V will have a top speed approaching 240 mph (386 km/h)". Hennessey plans to offer a limited run of only 24 units for the 2016 model year.

GM adds 1,200 jobs at Detroit-Hamtramck plant

General Motors is making a big move at its Hamtramck, MI, factory, announcing it will add a second shift and hire over 1,200 workers within the next several months. It's expected that by early 2016, the factory will employ over 2,800 workers to build the Chevrolet Volt, Impala, Malibu, Cadillac ELR, and by early next year, the new CT6. According to GM Hamtramck spokesperson Courtney Zemke, 40 of the 1,200 positions are for salaried employees, while the remainder will be hourly positions. As for where these employees will go, positions are being made available across the factory, so GM isn't focusing on any particular area for its new hires. It's a similar story behind the hiring surge itself. GM said in its press release that the "second shift is necessary to meet forecasted market demand," a position Zemke reiterated. It's a matter of demand across the plant's portfolio, rather than any one particular product seriously outstripping supply. Naturally, the United Auto Workers is happy with the move. "The workforce at Detroit-Hamtramck is second to none," UAW Local 22 Shop Chairman Don LaForest said in the attached release. "We appreciate the opportunity to expand our UAW-GM family." Hiring is going on now, with the second shift slated to get underway in early 2016. GM's Detroit-Hamtramck Assembly to Add Second Shift and More Than 1,200 Jobs Plant will nearly double its workforce by early 2016 2015-10-22 DETROIT – General Motors is nearly doubling its workforce at Detroit-Hamtramck Assembly by adding a second shift and more than 1,200 hourly and salaried jobs. The addition of a second shift will increase the plant's workforce to approximately 2,800 people when hiring is completed. The second shift is necessary to meet forecasted market demand for the five cars produced at Detroit-Hamtramck. "This is the result of the award-winning vehicles Detroit-Hamtramck produces and the confidence GM has in our team to build world-class quality for our customers," said Plant Manager Gary West. Second shift hiring is underway, and the shift is scheduled to begin operations in early 2016. "The workforce at Detroit-Hamtramck is second to none," said UAW Local 22 Shop Chairman Don LaForest. "We appreciate the opportunity to expand our UAW-GM family." The 4.1 million-square-foot Detroit-Hamtramck Assembly opened in 1985. GM has invested $1 billion in the plant over the last six years, making it one of the company's most-agile manufacturing facilities in North America.