1983 Cadillac Coupe Deville on 2040-cars

Auto blog

Autoweek divulges details on Presidential limo

Ever since the latest presidential limousine, also known as The Beast, debuted in 2009, we've wondered what's underneath that black Cadillac body. We already know a few details, like the fact it isn't a Cadillac at all, but a very heavy duty truck chassis from General Motors with a body that resembles a super-sized Caddy. Autoweek, however, has managed to extract new details from veteran Secret Service agents about the closely guarded presidential limo. Their methods, of course, are classified.
Designed to be a rolling office, bunker and escape pod all in one, the current presidential limo is far different from previous presidential state cars, which were heavily modified production vehicles. As we would expect, The Beast uses thick, military-grade body armor (eight inches on the doors), an armored fuel tank, special run-flat tires with Kevlar lining, an encrypted satellite phone, a fully sealed cabin with its own oxygen supply and a trunk full of weapons and medical equipment that includes a supply of the President's blood type (in case the car gets cut off from the ambulance that's always present in the President's motorcade).
The Beast also comes with a Halon fire-suppression system, night vision and is powered by a V8 engine, which we already knew runs on gas and not diesel, that returns an EPA-unfriendly estimated 3.7 miles per gallon. The Secret Service operates a fleet of 12 limos and each Beast costs $1.5 million. Lastly, AW estimates that the 18-foot-long state car weighs 15,000 pounds, and each Secret Service agent that drives the car must be specially trained to maneuver such a massive vehicle.

GM recalls 61k more vehicles in three campaigns

Following a stop-delivery order for its new midsize trucks and a rash of recent recalls, General Motors is issuing three more campaigns covering 60,575 vehicles in North America with 57,182 of them in the US. As of October 1, the automaker has issued a total of 74 recalls (see the ridiculously long chart to the right) this year covering 26,495,070 units in the US.
The largest campaign covers 46,873 examples in the US of the 2008-2009 Pontiac G8 and 2011-2013 Chevrolet Caprice Police Patrol Vehicle imported from Australia. It's possible for the driver's knee to hit the key and make it move from the "Run" to "ACC" position while driving. GM says its Holden division is developing a fixed-blade key that's supposed to fix the problem by only allowing it to rotate toward the "On" position. There has been one crash caused by this fault but no injuries or fatalities.
The second recall is for 10,005 units of the 2004-2007 Cadillac CTS-V and 2006-2007 Cadillac STS-V because "the fuel pump module electrical terminal may overheat." This can cause a flange to melt and allow the pump to leak fuel. GM specifies that the remedy for the CTS-V is replacing the fuel module and fuel tank jumper harness, but it doesn't specify how the STS-V is being repaired.

Cadillac SRX production moving to TN, next-gen Equinox going to Mexico

It's a good week for the town of Spring Hill, TN, as General Motors has announced that its factory in the city of 31,000 will receive a $185 million contract to produce engines. On top of that, the next-generation Cadillac SRX crossover will be built at the factory (NA models are presently built in Ramos, Arizpe Mexico), which was once famous for being the home of GM's now-defunct Saturn brand.
The factory is one of GM's six facilities around the globe that will screw together the company's new line of three- and four-cylinder Ecotec engines. Spring Hill currently builds the 2.0-liter, turbocharged Ecotec, as well as the naturally aspirated 2.4 and 2.5-liter variants.
Spring Hill's vehicle assembly lines were idled in 2009, but were reactivated in 2011. The SRX is just one of the products meant to benefit from last year's $350-million investment, and should have a positive impact, creating or retaining around 1,800 positions at the factory.