2005 Cadillac Cts Base Sedan 4-door 3.6l on 2040-cars

Auto blog

How Cadillac improved power output in 2016 ELR by 25 percent

Earlier this year, Cadillac announced that the 2016 ELR would come with a big price drop and a powertrain that packs 25 percent more power output. That's a lot more oomph, but it didn't sound like the Caddy engineers made any major changes to the engine or motors. So, what happened? Let's refresh our memories with the numeric details. The 2016 car is 1.5 seconds quicker to 60 miles per hour than the 2014 model (there was no 2015), down to 6.4 seconds. The 2014 put out 295 pound-feet of torque. For 2016, it will be 373 lb-ft. The specific breakdown of the various components in the powertrain has not been disclosed, but from what we can tell, the two electric motors and the 1.4-liter inline-four engine in the new ELR are not that much different than those in the old one. Sam Abuelsamid, senior research analyst at Navigant Research (and former writer here at Autoblog) said that any of the unspecified upgrades would be difficult to tell on a part-by-part basis, but the overall effect will be noticeable. "The changes to the ELR as I understand them are analogous to getting more performance out of a 1965 Mustang with the entry version of the 289 cubic-inch V8. You can replace the carburetor with a larger version that enables more air and fuel to flow into the engine, thus producing more power. The basic engine hasn't changed, but power capability is being unleashed by feeding it more." "Cadillac has changed components in the power electronics to enable more current flow into the motor and thus produce more torque. When you do this in the Mustang, you probably need to replace the rear axle gears and use a beefier clutch to transmit the power to the wheels. Similarly, the ELR probably has some upgraded clutches, bearings, and gears to withstand the increased total output." Cadillac spokesperson David Caldwell told AutoblogGreen in an email that the new ELR does indeed have more than just new lines of code. "One could not 'reflash' a previous ELR to get the performance of a 2016," Caldwell said. "If one only changed software you would not get the performance upgrade fully, as the 2016 creates higher current, more power. So these have been upgraded physically – hardware.

2015 Chevy Silverado, GMC Sierra recalled for steering issues

DETROIT — General Motors Co is recalling more than 1 million pickup trucks and sport utility vehicles in the United States due to issues with a temporary loss of power steering, the National Highway Traffic Safety Administration said. The recall is for 2015 models. They are: the Chevy Silverado 1500, Suburban and Tahoe, GMC Sierra 1500, Yukon and Yukon XL and Cadillac Escalade. The problem may cause difficulty steering the vehicle, especially at low speeds, increasing the risk of a crash, the auto safety regulator said in a document dated Sept. 12. The document did not highlight any reports of accidents and injuries, because of the power steering issue. GM dealers will update the power steering module software, free of charge for owners of the affected vehicles. In 2014, the No.1 U.S. automaker had recalled nearly 800,000 pickup trucks worldwide because of the same problem. GM did not immediately respond to a request for comment.Related Video:

GM struggles to sell small cars, plans to lay off 2,084 employees at two plants

Due to low demand for some of its vehicles, General Motors plans to cut 2,084 jobs at its assembly plants in Lordstown, OH and Lansing, MI. At the same time, the automaker also announced plans to invest approximately $900 million in three of its facilities – the Toledo Transmission Operations in Ohio, Bedford Casting Operations in Indiana, and Lansing Grand River in Michigan - for future products. GM will discontinue the third shift at both the Lansing Grand River plant and the Lordstown, OH plant. The Cadillac ATS, Cadillac CTS, and Chevrolet Camaro are made at the automaker's plant in Michigan, which currently has 2,700 employees. The move to eliminate the third shift affects 810 hourly workers, as well as 29 salaried employees, starting on January 16th. The plant in Lordstown, OH currently has 4,500 employees and makes the Chevrolet Cruze sedan. The plan to discontinue the third shift will affect 43 salaried workers and 1,202 hourly employees and will start on January 23rd. As Fortune points out, sales of the Cruze are down 20 percent through October, while sales of the Cadillac ATS and CTS were down 17 percent through the same period of time. In addition to cutting the third shift at both assembly plants, the automaker plans to invest a total of $900 million between three of its facilities for unnamed future products. GM's Toledo Transmission Operations will receive $667.6 million, the Lansing Grand River Assembly plant will receive $211 million, and the automaker's Bedford Casting Operations will get $37 million. Last year, GM cut roughly 500 jobs from its Orion Township factory due to slow sales of the Chevrolet Sonic and Buick Verano, with surging crossover and SUV sales as the most likely culprit. With GM posting much healthier sales figures for the Chevrolet Equinox and Cadillac XT5 compared to the ATS, CTS, and Cruze, it looks like compact SUVs are to blame for this year's layoffs as well. Related Video: News Source: Fortune, General MotorsImage Credit: REUTERS / Rebecca Cook Hirings/Firings/Layoffs Plants/Manufacturing Cadillac Chevrolet GM Coupe Sedan Lordstown Ohio