2001 Cadillac Etc Eldorado 2 Door Car Vehicle 16" Rims V8 Northstar Low Mile 63k on 2040-cars

Auto blog

Cadillac issues stop sale on ATS to recall 82k units

Cadillac is issuing a recall on 82,620 examples of the 2013-2016 ATS worldwide to fix a compliance issue with the sunroof controls. Until a service bulletin goes out to take care of things, there's also a stop sale on the luxury compact in the United States, The Detroit News reports. Of the affected models, 63,665 are in the US, according to a statement sent to Autoblog, and 7,922 of them are in Canada. The problem is actually the same issue as a recall on nearly 59,000 examples of the 2013-2015 ATS in the US in February. In them, the controls for the tilt and slide of the roof aren't recessed enough to meet government standards for the force necessary to operate the buttons. The Feds believe that someone could accidentally activate the auto-close and potentially be at risk. At the time, Cadillac dealers installed a new trim plate to add the needed clearance. In the latest update, the company is adding the 2016 model year, and according to The Detroit News, 70 percent of the cars from the original campaign also need another new trim plate. Unsurprisingly for such a minor defect, there are no known crashes, injuries, fatalities, or customer complaints related to this issue, according to the announcement by General Motors. Cadillac ATS Statement: General Motors is recalling 63,665 Cadillac ATS sedans in the United States from the 2013-2016 model years because the power-operated roof panel systems on these vehicles will auto-close when the non-recessed portion of the "Slide" or "Tilt" switches are pressed and the roof panel is open. Because these switches are not fully recessed, they can be actuated with less force than required to comply with applicable federal standards. GM knows of no crashes, injuries or fatalities related to this issue and has received no customer complaints. The total population of the recall including Canada, Mexico and exports is 82,620. Transport Canada Recall # 2015322 Recall Date 2015/07/21 Notification Type Compliance Mfr System Electrical Manufacturer Recall Number 15568 Units Affected The number of vehicles or components affected by the recall. 7,922 Category Car Recall Details Certain vehicles equipped with power-operated sunroof system may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 118 - Power-Operated Window, Partition and Roof Panel Systems.

Autoweek divulges details on Presidential limo

Ever since the latest presidential limousine, also known as The Beast, debuted in 2009, we've wondered what's underneath that black Cadillac body. We already know a few details, like the fact it isn't a Cadillac at all, but a very heavy duty truck chassis from General Motors with a body that resembles a super-sized Caddy. Autoweek, however, has managed to extract new details from veteran Secret Service agents about the closely guarded presidential limo. Their methods, of course, are classified.
Designed to be a rolling office, bunker and escape pod all in one, the current presidential limo is far different from previous presidential state cars, which were heavily modified production vehicles. As we would expect, The Beast uses thick, military-grade body armor (eight inches on the doors), an armored fuel tank, special run-flat tires with Kevlar lining, an encrypted satellite phone, a fully sealed cabin with its own oxygen supply and a trunk full of weapons and medical equipment that includes a supply of the President's blood type (in case the car gets cut off from the ambulance that's always present in the President's motorcade).
The Beast also comes with a Halon fire-suppression system, night vision and is powered by a V8 engine, which we already knew runs on gas and not diesel, that returns an EPA-unfriendly estimated 3.7 miles per gallon. The Secret Service operates a fleet of 12 limos and each Beast costs $1.5 million. Lastly, AW estimates that the 18-foot-long state car weighs 15,000 pounds, and each Secret Service agent that drives the car must be specially trained to maneuver such a massive vehicle.

Cadillac XT4 crossover reveals its lighting

The upcoming Cadillac XT4 compact crossover has once again been spotted, this time with less camouflage and an update to its lighting. Specifically, the little crossover is sporting production lighting front and rear, and it's sure to make the luxury SUV one of the boldest-looking Cadillacs. Part of the reason for this comes from the taillights. As we suspected from the last set of spy shots, the XT4 will have highly distinctive lights that run the full height of the C-pillar. Though it's a similar design to that of the Escalade, it's made more interesting by the significant forward rake of the rear pillar. Not only that, but that pillar is quite thick, too. The look is actually reminiscent of the old CTS wagon. Moving around the side, the reduced camouflage reveals that the doors and quarter panels are fairly conservative and lacking in many creases or bulges. We can make out the edges of what will likely be black plastic fender flares and rocker panel cladding. Finally reaching the front, we see that the headlights are similar to those of many current Cadillacs, including the recently refreshed XTS sedan. The main part of the lamp starts high up and is slightly horizontal like the Escala concept, but they extend over the fenders and a strip of LEDs descends down the front. A previous report noted the XT4 will be built in Kansas on the Chevy Malibu platform. That means it will be a front-drive-based vehicle likely offering both front- and all-wheel-drive. Under the hood will probably be at least one turbocharged four-cylinder engine, with a second, more powerful upgrade option a possibility. We expect to see the fully revealed model to show up by the end of 2018. Related Video: Featured Gallery Cadillac XT4 spy shots View 15 Photos Image Credit: Brian Williams Spy Photos Cadillac Crossover SUV Luxury cadillac xt4 cadillac xt3