1995 Cadillac Eldorado Base Coupe 2-door 4.6l 80k Low Miles No Reserve on 2040-cars

Auto blog

Don Draper's 1965 Cadillac Coupe de Ville up for auction

Few have ever nor ever will embody the sheer confidence and style of Don Draper, the main character on the hit AMC drama Mad Men. But if you can't quite match his style, at least you can drive his car. Now that the series has now concluded its eight-year run, the studio behind it is selling off a whole mess of artifacts from the show through ScreenBid, a specialist Hollywood memorabilia auctioneer. There's a good 1,300 lots up for grabs, from props to costumes. But the lot that's caught our attention is this 1965 Cadillac Coupe de Ville. Don picked this car up in the fifth season and drove it until the penultimate episode. These are the wheels he (spoiler alert!) drove across the country, got repaired in Oklahoma, and ultimately gave to a kid working at the motel before making his way by bus to the Bonneville Salt Flats in the final episode. At the time of writing, bidding had reached $25,000 with four days still to go. Cadillac first used the de Ville as a trim level on the Series 62 before spinning it off into its own model line. 1965 was the first year of the third-generation de Ville, stretching a massive 224 inches (over 18 and a half feet!) long. Powering over 4,600 pounds of personal American luxury was an equally massive 7.0-liter V8 that drove 340 horsepower through a three-speed automatic transmission. The name wasn't retired until 2005 when the final DeVille (as it was styled by then) was replaced by the DTS, which itself was shorthand for DeVille Touring Sedan. Cadillac produced the last DTS in 2011, finally putting to rest a name that had, in one form or another, been used since 1949. Few cars had the kind of presence that the third-gen Coupe de Ville did, though, and Draper knew it. Or at least the show's producers did.

Expect the Cadillac XT3 small crossover in late 2018

Cadillac's sedan-heavy lineup can't complete in this crossover-crazy market, it seems. The Detroit News spoke to Cadillac boss Johan de Nysschen and found out some more details about the brand's plan to alter its lineup to cater more to current consumer tastes. It's no surprise that these plans would include a small crossover, because de Nysschen has been talking about a vehicle smaller than the XT5 like this since at least 2015. The report also pins the Fairfax Assembly Plant, where GM builds the Buick LaCrosse and the Chevrolet Malibu, as the site for what could be called the XT3's production. That's not an immediately obvious choice, since the LaCrosse and Malibu are based on the latest evolution of the Epsilon platform, known as E2XX. And the XT5 is based on a crossover version of that same platform (known as C2XX), while XT3 is expected to be smaller than the XT5. So perhaps there's a different assembly line going into Fairfax, or the C2XX platform can be significantly shortened. We assume that the XT3 would be built on a smaller platform, perhaps the Gamma II that underpins the Chevrolet Trax and Buick Encore – which are built in either South Korea or Mexico, depending on which market they are to be exported to. The Encore is selling very well for Buick, with sales figures increasing through late last year. Another possibility is the D2XX platform that underpins the Chinese-built Buick Envision and the GMC Terrain and Chevrolet Equinox, perhaps with assembly happening at the CAMI plant in Ontario. At this early stage, without confirmation of GM as to what platform the XT3 will use or where it will really be built, it's too early to say what the Fairfax rumor means. This isn't the first time we've heard about a small Cadillac crossover. Back in 2015, de Nysschen told us to expect it sometime in 2018. But later that year, speaking to Reuters, he posited that it'd be closer to 2019. The Detroit News says de Nysschen told them it'll launch in the second half of 2018, splitting the difference between what we'd heard previously. Remember, Cadillac's only two vehicles in the segment are the XT5 and Escalade. We know that the brand is almost certainly scrambling to fill the holes in that side of the lineup. We think a three-row crossover will slot between the two, probably called the XT7.

This '59 Cadillac is now on display at Toyota's museum in Japan

The Toyota Automobile Museum is different from a lot of other automaker collections in one very interesting way: It doesn't focus solely on Toyota's own automobiles. While the home team is certainly well represented, the love is spread to plenty of non-Toyota brands and vehicles that are significant to automotive history. And that permanent collection now includes the 1959 Cadillac Eldorado Biarritz convertible you see here. Yes, the '59 Caddy has the biggest tail fins ever, which makes it measurably significant. You still wouldn't expect to see it in a museum in Japan, though. After updates to the facility and its exhibits finish early next year, the 67-vehicle collection will also include such greats as a Renault 5 (known here as the Le Car), a '64 Ford Mustang, an Audi Quattro, a first-gen Honda Insight, and a Lotus Elite. Someone over there has good taste. You can visit the Toyota Automobile Museum the next time you're in Nagakute City, which is right outside Nagoya. We're booking our tickets now. Related Video: Cadillac Toyota Automotive History cadillac eldorado