1 Owner 96 Cadillac Deville Concours 4dr Northstar 4.6l 73k Orig Mi De Ville on 2040-cars

Auto blog

Chinese-made Cadillac CT6 Plug-In starts US sales

General Motors has started US sales of the Cadillac CT6 Plug-In after taking its first domestic deliveries of the China-produced sedan last month. The model is GM's first new plug-in hybrid in the US since the automaker discontinued sales of the ELR extended-range plug-in last year. The arrival and sales, first reported by InsideEVs, were confirmed by Cadillac spokesman Andrew Lipman. Not surprisingly, the sedan isn't cheap, as the CT6 Plug-In is priced at $75,095, or almost $12,000 more than the gas-powered variant, though that figure doesn't include federal and state tax credits for electric vehicles. For that tab, buyers get a 335-horsepower luxury car that can go 31 miles on electricity alone, and 0-60 miles per hour in a little over 5 seconds. The model gives GM three plug-in vehicles to sell to the American public, or the same number US competitor Ford offers. InsideEVs estimates that about 100 of the sedans have been delivered to US dealers, so the car remains a relatively low-volume affair. By comparison, GM's Chevrolet division has sold 5,563 Volt extended-range plug-ins and 3,092 Bolt electric vehicles through March. Cadillac sold 534 units of the ELR in 2016 after moving 1,024 the previous year. GM opted to produce the plug-in hybrid in China because of that country's receptiveness to new models that feature alternative and environmentally friendlier powertrains. Additionally, such production shortens the distance to the CT6's battery maker LG Chem, which is producing the car's battery packs in South Korea. On that note, GM has previously estimated that the Cadillac CT6 Plug-In will move more units in China than in the US. Related Video:

Cadillac considering more radical ATS-V

Cadillac is stepping up its performance game with the launch of the new ATS-V and CTS-V, but it's not about to rest on the laurels it removed from its own badge. While it's tipped to launch additional V models in the future, the latest word is Caddy could also come out with an even more extreme version of the ATS-V in the near future. According to Car and Driver, the prospect is on the table: "We might have something down the road that is a little bit more aggressive," chief engineer Dave Leone said, while another source pegged its potential arrival for 2017. It's too early to say what would constitute the more extreme model. The magazine points toward the Mercedes-AMG Black Series as an example. Jaguar took a similarly extreme approach with the XKR-S GT, as BMW has with the M3 GTS. As it is, the ATS-V is offered in both coupe and sedan variants with a 3.6-liter twin-turbo V6 producing 464 horsepower channeled to the rear wheels through a six-speed manual. Cadillac reportedly considered employing a dual-clutch transmission and all-wheel drive, but went the old-school route to avoid excess weight and (no doubt) cost.

Super Cruise’s failsafes

Even though Super Cruise is not a fully autonomous system, it incorporates redundancies like those used in aircraft to ensure failsafe operation. Before taking off on a 700-mile, 11-hour test drive of the system — and putting my life in its hands without my hands on the wheel — I sat down with Daryl Wilson, lead development engineer for Super Cruise, to get a deep dive into the system and its critical safety backups. Autoblog: First, what makes Super Cruise different from similar systems? Wilson: The key differentiator for Super Cruise is hand-free driving. It's an industry first in that respect. Our competitors require the driver at minimum to place their hands on the wheel with some frequency to ensure that the car knows that the driver is there. We don't. Two key technologies allow us to do this. One is our Driver Attention System, which is our methodology for making sure the driver is engaged with the vehicle and engaged with the road. This is a driver assist system, not a fully autonomous system. So it requires driver engagement. We use an infrared camera that constantly monitors the driver's face to determine the direction they're looking. We're looking for the driver to be what we call on-road — not on the center stack, not to left or right or down. That's all done by the tracking of the face. We also track that the eyes are open. It's infrared because at night you need to illuminate the face and you can't be shining a light into the driver's face. Then we have our lidar mapping that provides a foundation for control and redundancy to ensure safe performance. Autoblog: How does the mapping act as a redundant feature? Wilson: This system is only for use on divided, controlled access highways. What I mean by a divided highway is something more than a painted line between you and oncoming traffic. Whether that's a grassy area in between the lanes or a concrete barrier, anything that separates you from oncoming traffic. That's the divided highway part. The controlled access part is entrance ramps and exit ramps. Not with roads that cross at grade, with traffic crossing at the same level. To do that we geofenced these roads to ensure that operation is only allowed in these conditions. We don't just recommend you use it there; we ensure that you only use it there.