2011 Enclave Cxl Fwd Htd Lthr Quads Roof 3rd Row Bose Remote Start Flawless on 2040-cars

Auto blog

GM recalling 316k vehicles due to headlamp faults

General Motors has announced a recall covering 316,357 vehicles globally, due to the possibility of sporadic or permanent failure of the low-beam headlamps. 273,182 of these vehicles are in the United States, while the remaining affected units are in Canada, Mexico, and elsewhere. This recall includes the 2006-09 Buick LaCrosse (pictured above), 2006-07 Chevy TrailBlazer and TrailBlazer EXT, 2006-07 GMC Envoy and 2006 GMC Envoy XL, 2006-07 Buick Rainier, 2006-08 Saab 9-7X, and 2006-08 Isuzu Ascender. In an email sent to Autoblog, General Motors explains that if the headlamp driver modules are not functioning correctly, "the low-beam headlamps and daytime running lamps could intermittently or permanently fail to illuminate." GM states that this problem does not affect things like high-beams, turn signals, marker lamps, or foglamps. As of this writing, GM states it "has not been able to confirm whether the HDMs in these vehicles caused any vehicle accidents." The National Highway Traffic Safety Administration has been notified, but the recall has not yet posted to the government agency's website. Scroll down to read the full details in GM's email. General Motors is recalling 273,182 Buick LaCrosse sedans and Chevrolet, GMC, Buick, Saab and Isuzu midsize SUVs in the U.S. for possible intermittent or permanent loss of low beam headlamps. Affected models are: 2006-2009 Buick LaCrosse sedans; 2006-2007 Chevrolet TrailBlazer and 2006 TrailBlazer EXT; 2006-2007 GMC Envoy and 2006 Envoy XL; 2006-2007 Buick Rainier; 2006-2008 Saab 9-7X and 2006-2008 Isuzu Ascender midsize SUVs. If the headlamp driver modules is not operating correctly, the low-beam headlamps and daytime running lamps could intermittently or permanently fail to illuminate. This condition does not affect the high-beam headlamps, marker lamps, turn signals, or fog lamps. GM has not been able to confirm whether the HDMs in these vehicles caused any vehicle accidents. The total population, including the U.S., Canada, Mexico and exports from North America is 316,357. The NHTSA was sent the Part 573 information for this recall on November 25. It has not yet posted to the NHTSA website. Featured Gallery 2008 Buick LaCrosse CXS News Source: General Motors Recalls Buick Chevrolet GM GMC Isuzu Saab SUV Sedan chevy trailblazer buick rainier isuzu ascender

2017 Buick LaCrosse an evolution of sharp Avenir concept

After years as a bloated, uninspiring, but comfortable near-premium sedan, Buick has taken the wraps off a leaner, lither, far more stylish LaCrosse. The third-generation model has just made its debut at the 2015 Los Angeles Motor Show. While there's a lot to talk about, let's first address the new, Avenir-inspired sheetmetal. The fascia is basically the concept car smoothed over into production form, featuring the same winged trishield. In place of the chrome-trimmed waterfall, the LaCrosse gets a blacked-out, recessed grille with a chrome surround. It looks good in photos but it's better in person, adding a real sense of complexity and depth to the front end. The headlights and lower fascia, meanwhile, adhere closely to the concept. The same cannot be said of the LaCrosse's tail. While the taillight lighting pattern is similar, the overall shape of the lighting element is radically different, refining the design featured on the back of the Regal. Also gone, sadly, is the Avenir's boattail rear deck. Instead, the LaCrosse gets a small rear deck that curves up into a pleasant duckbill spoiler. The rest of the tail is pleasantly restrained. Perhaps the weakest point is the profile, where Buick has instituted a "split-spear" design, featuring a strong shoulder line above the rear wheel well, which sits below an even stronger character line that curves down and towards the front of the car. It strikes us as just a little too much, like the Impala. Underneath that sheetmetal, Buick has managed to trim nearly 300 pounds of body fat, nearly half of which came from the vehicle's actual structure. That 300 lbs, according to Buick's engineers, is equivalent to a Kenmore side-by-side refrigerator, in case you needed a helpful comparison. Despite the weight savings, Buick has upped the torsional rigidity for this new model by 15 percent. The LaCrosse's cabin features a strong, cockpit-like design, with a high, floating-bridge center console. This is possible due to Buick's adaption of the Electronic Precision Shift system, introduced earlier this month on the new Cadillac XT5. Despite the new-fangled console design, Buick's retained the wraparound cabin style introduced on the second-gen model. Based on a quick crawl around the interior, space is great in front, although ingress in back is somewhat difficult due to the roofline. You're probably wondering why we haven't said anything about the mechanicals just yet.

eBay Find Of The Day: 1946 Tucker Torpedo Prototype II hides a secret Riviera

The Tucker Torpedo is one of the great what-if stories of automotive history. Preston Tucker hoped to revolutionize the industry with a car unlike any other on the road at the time. However, due to a variety of problems, he only managed build 51 vehicles before closing shop. Over time, they have become highly sought-after; In 2012, one sold for $2.65 million at auction.
That brings us to this Tucker "replica" that you see above because it might be one of the ugliest monstrosities ever put together. However, we might extend some leniency to the creator, as the vehicle isn't actually trying to replicate the classic look of the 1948 Tucker Torpedo. Instead, it is attempting to reproduce an earlier prototype from 1946 that actually features that weird, trident nose. According to the seller, his uncle built the car as a labor of love and supposedly used actual plans from Tucker as inspiration.
Underneath all of the crazy changes is a 1971 Buick Riviera powered by a 455-cubic-inch (7.5-liter) Buick V8. Some of the replica's odder modifications include the front fenders that turn with the wheels and the fin running down the back. All three headlights work, but the one in the middle is only for the high beams. Oddly, the small hinged sections on the roof are meant to open to avoid hitting your head when getting in or out. Maybe the seller's uncle was a very tall guy?