Sdrive28i New 2 Dr Convertible Manual Gasoline 2.0l Dohc 16v 4-cyl Blk Sapph Met on 2040-cars

Auto blog

BMW unveils 2016 X5 M and X6 M super CUVs

The second-generation BMW X5 M and X6 M have officially made their arrival for the speed-obsessed, crossover-loving masses that aren't willing to turn to Mercedes-AMG or Land Rover Special Operations.
While the new models retain their 4.4-liter, twin-turbocharged V8s, power has increased from 555 horsepower to 567 ponies. Torque is up more significantly, climbing from 500 pound-feet to 553 pound-feet. The extra twist is slightly less accessible, with peak grunt arriving between 2,200 and 5,000 rpm, rather than the earlier model's 1,500 to 5,650. Still, we'll take the ten percent increase in torque as a net win.
The big powertrain switch sees the old X5/6 M's six-speed automatic replaced with an eight-speed Steptronic transmission from BMW M. This new gearbox feeds power to an xDrive all-wheel-drive system that can variably shuffle up to 100 percent of power to either axle. In conjunction with the force-induced thumper under the hood, this powertrain arrangement allows both M models to hit 60 miles per hour in just four seconds. That's a mightily impressive stat in a 5,000-plus-pound vehicle.

BMW X4 reclaims dash of utility with Clemson student project [w/videos]

BMW seems willing to exploit every automotive niche it can find with creations like the four-door, 'crossover coupe' X4 and X6. Of course, these designs come with a compromise. That svelte fastback means that they just can't haul as much cargo as a more traditional, boxier hatchback. Fortunately, students at Clemson University's International Center for Automotive Research might have a novel solution: the engineering graduate program has turned the crossover into a unique pickup.
Dubbed Deep Orange 4 concept, this functional prototype has an enclosed cargo area with a sliding glass panel that opens up to expose a pickup bed if more room is needed. Think of it as the GMC Envoy XUV of German crossovers. This isn't just an X4 with its roof hacked off, though. The students actually started with an X3 and grafted on this top later in addition to the two barn doors for access to the bed.
To make this project even more impressive, this pickup-crossover could conceivably be produced. The graduate students conducted an in-plant analysis of BMW's manufacturing abilities and went back to the university to create a plan for a low-volume vehicle that could actually be built. "The students working on this phase of the project did an excellent job of keeping costs down while finding optimal integration opportunities," said Rich Morris, vice president of assembly at BMW Manufacturing, in the university's release.

BMW 1 Series prototype packs direct water injection

Just a few months ago, BMW showcased an M4 that was modified to serve as the safety car for the MotoGP racing series. The flashing lights and emergency equipment, however, weren't the only modifications BMW made to the performance coupe. It also packed an innovative new water injection system. And now it's furthering the development of that system by running it in a 1 Series hatchback as well. Revealed at the BMW Group Innovation Days 2015 event, this five-door 1 Series packs a three-cylinder gasoline engine – like the one found in a Mini or i8 – but fitted with the direct water injection system. In this application, the system sprays a fine mist of water – yep, regular old H2O – right into the combustion chamber. While mixing water with gasoline normally wouldn't be recommended, in this case it evaporates immediately and helps cool the engine from the inside, allowing it to run at higher efficiency. That cooler running engine brings with it several benefits. It delivers improved fuel economy and lower emissions, to start. It also allows for an earlier ignition point, higher compression ratio, and higher boost pressure in turbocharged engines, delivering increased output. It even cuts down on engine knocking (where combustion occurs spontaneously), reduces wear and tear on the engine, and makes better use of lower octane levels. If that sounds like a win-win-win... win (we're losing count of all the wins here), it's because BMW just may be on to something. Of course it does require a water tank to be fitted on board, which means added weight, but instead of requiring the driver fill up the water tank, BMW has fitted this prototype with a system that replenishes the water level from the air conditioning system when the vehicle is switched off. So unless it's being driven in a particularly extreme climate, it doesn't even need topping up. Add one more "win" to the list, then. Extra power, improved real-world fuel economy: Direct water injection enhances efficiency. With direct water injection for turbocharged petrol engines, the BMW Group has again succeeded in enhancing the capabilities of conventional engine technology through an ongoing process of refinement and improvement. The precisely controlled injection of water into the engine cylinders produces a cooling effect that boosts power and torque, particularly when operating at or near full throttle, while at the same time reducing fuel consumption and emissions.