1966 Baja Beetle on 2040-cars

Auto blog

Brand new cars are being sold with defective Takata airbags

If you just bought a 2016 Audi TT, 2017 Audi R8, 2016–17 Mitsubishi i-MiEV, or 2016 Volkswagen CC, we have some unsettling news for you. A report provided to a US Senate committee that oversees the US National Highway Traffic Safety Administration (NHTSA) and reported on by Automotive News claims these vehicles were sold with defective Takata airbags. And it gets worse. Toyota and FCA are called out in the report for continuing to build vehicles that will need to be recalled down the line for the same issue. That's not all. The report also states that of the airbags that have been replaced already in the Takata recall campaign, 2.1 million will need to eventually be replaced again. They don't have the drying agent that prevents the degradation of the ammonium nitrate, which can lead to explosions that can destroy the airbag housing and propel metal fragments at occupants. So these airbags are out there already. We're not done yet. There's also a stockpile of about 580,000 airbags waiting to be installed in cars coming in to have their defective airbags replaced. These 580k airbags also don't have the drying agent. They'll need to be replaced down the road, too. A new vehicle with a defective Takata airbag should be safe to drive, but that margin of safety decreases with time. If all this has you spinning around in a frustrated, agitated mess, there's a silver lining that is better than it sounds. So take a breath, run your fingers through your hair, and read on. Our best evidence right now demonstrates that defective Takata airbags – those without the drying agent that prevents humidity from degrading the ammonium nitrate propellant – aren't dangerous yet. It takes a long period of time combined with high humidity for them to reach the point where they can rupture their housing and cause serious injury. It's a matter of years, not days. So a new vehicle with a defective Takata airbag should be safe to drive, but that margin of safety decreases with time – and six years seems to be about as early as the degradation happens in the worst possible scenario. All this is small comfort for the millions of people who just realized their brand-new car has a time bomb installed in the wheel or dashboard, or the owners who waited patiently to have their airbags replaced only to discover that the new airbag is probably defective in the same way (although newer and safer!) as the old one.

Volkswagen Cross Coupe GTE concept previews new midsize CUV... again

Volkswagen has taken a big step towards the long-awaited second model to be built at its Chattanooga, TN factory, introducing the two-row Cross Coupe GTE Concept at the 2015 North American International Auto Show. The relatively handsome two-row crossover borrows its basic styling language from the CrossBlue Concept that launched at the 2013 Detroit show (that we later had a brief chance to drive), and the CrossBlue Coupe from that year's Shanghai Motor Show. To be entirely frank, it just looks like a much more production-ready version of the Shanghai concept. The more aggressive elements of that model, like its rear taillights, rounded wheel arches, and aggressive front and rear fascias, have been toned down considerably. In other words, this concept almost wouldn't look out of place on the average road. Changes in the cabin are similarly minor, with the same basic design as the CrossBlue, complemented by a 12.3-inch digital instrument cluster and a 10.1-inch touchscreen display. While it's still quite clearly a concept car interior, it's not hard to imagine VW transitioning this cockpit into a production model. Riding atop the Volkswagen Group's MQB architecture – making it a relative, albeit distant, of cars like the VW Golf, Audi TT and the Euro-market Passat – the Cross Coupe GTE is motivated by a 3.6-liter VR6 that's been mated to not one, but two electric motors (one on each axle). The gas engine offers up 276 horsepower and 258 pound-feet of torque, while the front axle's electric motor generates 54 hp and 162 lb-ft of torque, and the rear can deliver a more robust 114 hp and 199 lb-ft of torque. That cacophony can be easily boiled down to this: the Cross Coupe GTE has a total system output of 355 hp and 280 pound-feet of torque, which is good enough to get the five-seater to 60 miles per hour in six seconds, on to a top speed of 130 miles per hour. As a plug-in hybrid, though, there's more to the Cross Coupe GTE then just its power output. Range plays a big role, and in that regard, this concept is fairly average. It can cover 20 miles when its 14.1-kilowatt-hour lithium-ion battery is charged up. Beyond that, the drivetrain can be set to a number of modes to optimize the behavior of plug-in-hybrid powertrain. In E-Mode, which can be locked in via a battery hold/battery charge mode, all 20 miles of range are available, although the Cross Coupe's driver will only have the 114-hp rear axle electric motor to work with.

America was the unexpected theme at the 2017 Detroit Auto Show thanks to Trump

President-elect Donald Trump was not in attendance at this year's Detroit Auto Show, but it sure seemed like he was the target audience for many of the press conferences and announcements surrounding the event. Several manufacturers chose to play up existing and future commitments to the US in general and American jobs specifically in their presentations to the press, and we're pretty sure that has everything to do with Trump's recent targeting of automakers on Twitter. To us, it seemed automakers were going on the offensive to try and preempt any future tweet-shaming for investing in auto manufacturing anywhere but the US. The pro-America sentiment started the week prior to the auto show, with Ford announcing that it would build several future electrified vehicles at its Flat Rock Assembly Plant in Michigan and also cancel a $1.6 billion factory planned for Mexico. Ford announced the two items on the same day, but the reality is that they likely have no relation to each other; the Mexican plant is being skipped because the company doesn't need the extra capacity to build the Ford Focus right now. Trump was still happy to share the news on Twitter. Then, on Sunday, FCA announced it would invest $1 billion in manufacturing plants in Ohio and Michigan to produce the new Jeep Wagoneer, Grand Wagoneer, and Wrangler-based pickup. It's not as though those potential new jobs were on their way out of the US, necessarily, but FCA took the opportunity to mention that plant upgrades at the Warren Truck Plant would allow the company to build Ram heavy duty trucks, which are currently assembled in Mexico, there. CEO Sergio Marchionne confirmed that Trump and his proposed tariffs had nothing to do with the decision. We certainly believe that, but we also have to believe that the timing of the release, positive outcome for America, and zero gain for Mexico were all orchestrated. Again, Trump sent out a victory tweet as if this had been his doing. Ford then used its press conference at the show on Monday to reiterate the plans for Flat Rock and also confirm that the Ford Bronco and Ranger nameplates will be returning to the US market, and that both will be built at a plant in Michigan. Announcements of manufacturing locations are usually aimed at the UAW, which certainly has a stake in these things, but again this one was broadcast to the auto show crowd in general.