No Reserve! Extra Clean 4x4 Stick Shift Truck on 2040-cars

Auto blog

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Ford F-150, Chevy Silverado, Toyota Tundra flunk IIHS headlight test

The Insurance Institute for Highway Safety put pickup truck headlights to the test and found that the majority of them were equipped with subpar units. The 2017 Honda Ridgeline was the only truck to earn a rating of "good." The large pickup truck test was comprised of the: 2016 to 2017 GMC Sierra, 2017 Nissan Titan, 2016 Ram 1500, 2016 to 2017 Chevrolet Silverado, 2016 to 2017 Ford F-150, and 2016 to 2017 Toyota Tundra. The Sierra's headlights earned a rating of "acceptable," the headlights found on the Titan and Ram 1500 were found to be "marginal," and the ones on the Silverado, F-150, and Tundra were rated as "poor." IIHS claims the F-150 was the most disappointing out of the large pickup trucks as both its halogen and optional LED headlights failed to provide adequate visibility during testing. The Ridgeline (which earned a "good rating"), is usually considered a midsize or small truck, though IIHS included it in the field of large pickups. The headlights on the 2016 Chevrolet Colorado, 2016 GMC Canyon, 2016 Nissan Frontier, and 2016 to 2017 Toyota Tacoma, which made up the small pickup truck group, all earned a rating of "poor." The IIHS claimed the Colorado had the worst headlights of any truck that was tested, as the base vehicle's units were only able to illuminate up to 123 feet in front of the car. The Ridgeline's headlights, for reference, were able to illuminate up to 358 feet in front of the vehicle. To conduct its test, the IIHS utilizes a special tool to measure how far light is projected out of the headlights in different driving situations. The trucks' headlights were tested in a straight line and in corners, while vehicles with high-beam assist were given extra praise. The headlights on the pickup trucks also mimic the testing that was done on small SUVs and cars earlier this year. Next year, automakers will need to fit their vehicles with headlights that earn a rating of either good or acceptable to earn the IIHS Top Safety Pick+. Related Video:

Toyota retires robots in favor of humans to improve automaking process

Mitsuru Kawai is overseeing a return to the old ways at Toyota factories throughout Japan. Having spent 50 years at the Japanese automaker, Kawai remembers when manual skills were prized at the company and "experienced masters used to be called gods, and they could make anything." Company CEO Akio Toyoda personally chose Kawai to develop programs to teach workers metalcraft such as how to forge a crankshaft from scratch, and 100 workstations that formerly housed machines have been set aside for human training.
The idea is that when employees personally understand the fabrication of components, they will understand how to make better machines. Said Kawai, "To be the master of the machine, you have to have the knowledge and the skills to teach the machine." Lessons learned by the newly skilled workers have led to shorter production lines - in one case, 96percent shorter - improved parts production and less scrap.
Taking time to give workers the knowledge to solve problems instead of merely having them "feed parts into a machine and call somebody for help when it breaks down," Kawai's initiative is akin to that of Toyota's Operations Management Consulting Division, where new managers are given a length of time to finish a project but not given any help - they have to learn on their own. It's not a step back from Toyota's quest to build more than ten million cars a year; it's an effort to make sure that this time they don't sacrifice quality while making the effort. Said Kawai, "We need to become more solid and get back to basics."