2012 Toyota Prius V 5-door Wagon (grey) on 2040-cars

Auto blog

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Toyota vows to fix poor Camry crash test result that irked Consumer Reports

Many Toyota vehicles haven't been performing well in the Insurance Institute for Highway Safety's (IIHS) small overlap frontal crash test, and the Camry is one of them. The 2012 and 2013 Camry both received "Poor" ratings, IIHS' lowest rating, in the test, which spurred Consumer Reports to take the car off its "Recommended" list. In response to the low ratings in the small overlap frontal test, and in a bid to maintain its best-seller status, Toyota will make changes to the Camry to improve its IIHS safety rating and to enhance its design, The Detroit News reports.
The Camry performed well in the moderate overlap frontal, side, roof strength and head restraints and seats crash tests, receiving "Good" ratings, IIHS' highest rating, in all four tests. That was enough for IIHS to award it a Top Safety Pick rating, just not TSP+.
Bill Fay, head of Toyota's US division, reportedly says, "It's still a five-star car. It still does very well in all the IIHS tests. It did not in [the small overlap frontal crash test], and we're busy making the necessary adjustments so that we can address that."

Oh, Kei Go: Toyota set to enter JDM minicar market?

Toyota is looking to get bigger... by going smaller. The Japanese automaker is looking to enter the kei car market, a popular segment in its homeland. Kei cars are small vehicles with restrictions on length (11.15 feet), width (4.86 feet), engine size (660 cubic centimeters) and power output (63 horsepower). Currently, Toyota is the only Japanese automaker not producing vehicles for this segment, but that is set to change, according to a report from The Wall Street Journal.
Thanks to its relationship with Daihatsu, Toyota can jump right into the kei car game. Daihatsu is one of the largest producer of kei vehicles and it is currently owned by Toyota.
Although kei cars are restricted in terms of size and power, they are not restricted by technology. Automakers utilize different drive configurations, powertrains and amenities to keep their cars fresh. Daihatsu and Toyota plan to work together to produce Toyota-branded kei cars. The two companies will utilize Toyota's knowledge of electric and hybrid systems to produce efficient little vehicles for the Japanese market.