Ultimate Hunting Machine (toyota Land Cruiser on 2040-cars

Auto blog

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.

Toyota settles first wrongful death suit related to unintended acceleration

Toyota's sales seem to have rebounded from the unintended acceleration issues from 2009 and 2010, but the automaker is far from done dealing with this situation. Following a settlement worth up to $1.4 billion for economic loss to affected vehicle owners, Toyota has settled rather than going to trial in a wrongful death lawsuit stemming from an accident in Utah in 2010 that left two passengers dead. This isn't the first case in which Toyota has settled, but it was the first among a consolidated group of cases being held in Santa Ana, CA.
According to The Detroit News, this case was scheduled to take place next month, and it was for a November 2010 incident in which Paul Van Alfen and Charlene James Lloyd were killed in a Camry when, based on findings by the Utah Highway Patrol, the accelerator got stuck causing the car to speed out of control and hit a wall; the terms of the settlement were not announced.
The article says that while Toyota will settle on some cases, it doesn't plan on settling on all of them as it still wants to be able to "defend [its] product at trial." This will probably be the case in suits claiming that software for the drive-by-wire accelerator was the cause of an accident in a Toyota or Lexus vehicle. The question of whether or not the electronic accelerator played any role in this problem has been a hot-button topic since the beginning. Toyota has issued recalls in the past to attempt to prevent unintended acceleration caused by trapped floor mats and faulty accelerator pedals, but it also says driver error was to blame in some instances.

Toyota recalls power window switches for 6.5 million vehicles [UPDATE]

UPDATE: There was one incident of someone in the US getting a burn to the hand from this issue Toyota spokesperson Cindy Knight tells Autoblog that. "We have 11 reports where part of the door trim and/or switch was burnt," she said. The company isn't aware of any crashes from the problem, though. Because of a potential short circuit in the driver's side power window switch, Toyota is recalling 6.5 million vehicles worldwide, Reuters reports. Of those, the automaker says around 2 million are in the US. The affected models here are: 2007 and 2009 Camry and Camry Hybrid 2009-2011 Corolla 2008-2011 Highlander and Highlander Hybrid 2009-2011 Matrix 2006-2011 RAV4 2009-2011 Sequoia 2009-2011 Tundra 2006-2010 Yaris 2009-2011 Scion xB 2009-2010 Scion xD According to Toyota, the switch might not have received adequate lubricant grease during manufacturing, and over time this could lead to a short circuit. In a worst-case scenario, the part might even overheat, melt and cause a fire. As a fix, dealers will inspect the component on these vehicles and apply heat-resistant grease to it, and any broken examples will have an internal circuit board replaced. Toyota already issued one recall for this problem in 2012 when it had to repair 7.5 million vehicles globally from the 2007-2009 model years, including 2.5 million in the US. These latest models had the grease applied in a different way. Related Video: Toyota Recalls Certain Vehicles for Power Window Master Switch October 21, 2015 TORRANCE, Calif., Oct. 20, 2015 – Toyota Motor Sales, U.S.A., Inc. today announced that it is conducting a safety recall of approximately 2,000,000 vehicles related to the driver's side Power Window Master Switch. The involved vehicles include certain: 2007 and 2009 Camry and Camry Hybrid 2009-2011 Corolla 2008-2011 Highlander and Highlander Hybrid 2009-2011 Matrix 2006-2011 RAV4 2009-2011 Sequoia 2009-2011 Tundra 2006-2010 Yaris 2009-2011 Scion xB 2009-2010 Scion xD The Power Window Master Switch in the involved vehicles may have been manufactured with insufficient lubricant grease. If not enough grease is applied, under certain conditions the switch may develop a short circuit that can cause the switch assembly to overheat and melt. A melting switch can produce smoke and potentially lead to a fire. Toyota previously recalled certain 2007-2009 model year vehicles for a similar condition.