1988 Toyota Land Cruiser 4 Door Utility 4x4 on 2040-cars

Auto blog

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Automakers paying Chinese dealers for lower-than-expected sales

The Chinese dealers vs. foreign manufacturers story won't quit. It began with a story on the struggles faced by FAW-Toyota joint venture dealers, with supposedly 95 percent of the showrooms losing money, and 10 percent of them doing so poorly that they'd have to exit the business. The problem is mandated sales targets, most set when the country's economy was racing. Now that things have slowed, China's dealers are swimming in unsold cars and the costs to keep them. In the case of FAW-Toyota, dealers asked Toyota to hand over 2.2 billion yuan ($355 million) to help address the situation. That was followed by a report noting the issues that Honda, BMW, and Nissan dealers are having with the same issue, revealing that the Chinese Automobile Dealers Association (CADA) had taken the highly unusual step of writing to the Chinese government to complain. Now Reuters reports that CADA is not only pressing its case even harder, it's being open about it: it announced that BMW agreed to pay dealers 5.1 billion yuan ($820 million) to alleviate poor profits last year. Unnamed sources said Audi has thrown 2 billion yuan into the kitty for subsidies, and Daimler has contributed "about 1 billion yuan" to its dealers. The battle isn't just about 2014, but how business will be run in 2015 as well: Chinese Porsche dealers have requested the automaker lower its 2015 target of 64,000 cars, which would be a 40-percent increase on its 2014 sales of 46,931 vehicles. One analyst called it "shocking" that the CADA has taken its fight public, while CADA comments continue to imply that dealers have been railroaded to the cliff's edge without recourse. "Due to the difference in status," it's deputy secretary said, "individual dealers are not willing to, or don't dare to, talk frankly with the carmakers...." Both parties need one another, so they'll figure out a way to make it work – but that could mean acknowledging the Chinese market is behaving more like a mature one, not an emerging one. News Source: ReutersImage Credit: Lintao Zhang/Getty Images Earnings/Financials Audi BMW Porsche Toyota Car Dealers Luxury

Toyota Tacoma X-Runner dead

A report from last week indicated that Toyota will begin trimming models from its Tacoma lineup starting with the Regular Cab in 2015, but the popular pickup will lose its first variant even sooner than that. For 2014, the Tacoma X-Runner has been dropped, though the company's SR Package could fill the need of those looking for a sporty pickup.
The X-Runner has been around since 2005 with its lowered stance, aftermarket-look body kit and bright paint colors, all of which are offered available only on V6-powered, two-wheel-drive Access Cab Tacomas. The new SR Package sounds like it will offer a somewhat similar appearance, though, with a monotone exterior paint scheme in limited colors accented with smoked headlights, but it will only be offered on Pre-Runner and 4x4 models. Other changes being made to the 2014 Tacoma include a new wheel option with black finish, a wider variety of Entune multimedia features, and the option to have the backup camera display moved from the rearview mirror to the audio system head unit.