2012 Toyota Fj Cruiser Trail Teams 4.0l 4x4 Dvd 22k Mi Texas Direct Auto on 2040-cars

Auto blog

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Recharge Wrap-up: 'Racing Extinction' Tesla, Wards praises 3 hybrids

The makers of Racing Extinction used a tricked out Tesla Model S for their movie. The artists and activists used the electric car as a platform to project images from nature in various cities to raise awareness about imperiled wildlife. In addition to a the high-powered projector, the Model S features a electroluminescent paint job that emits light to mimic creatures found in the wild, such as bioluminescent sea life. It also has a thermal imaging camera in the front of the car with a filter to view CO2 emissions. Check it out in the video above, and read more at Ecomento. WardsAuto has named the 2016 Hyundai Sonata Plug-In Hybrid's powertrain to its list of 10 Best Engines. As the first plug-in hybrid to make the list, WardsAuto World Editor-in-Chief Drew Winter praises Hyundai engineers for their "impeccable job blending fuel efficiency with refinement and daily usability." Wards notes the car's smooth transitions between electric and hybrid modes, and a well-connected six-speed automatic transmission. Other electrified vehicles to make the list are the 2016 Chevrolet Volt and 2016 Toyota Prius. Read more from Hyundai, at Green Car Reports. FEV's plug-in hybrid battery pack has gone into vehicle series production. The 10-kWh battery pack, developed by the German development services provider, offers an all-electric range of about 30 miles. FEV says its battery management algorithms are just as important as choosing the right battery hardware. "The core system for the battery development is our own mature battery management system (BMS), now in its third generation, that together with optimized algorithms allows a very reliable and stable control of the battery," says FEV's Dr. Michael Stapelbroek. Read more at Green Car Congress, or in the press release from FEV below. Hybrid Vehicle Goes Into Series Production FEV development competence consists of batteries, controls, as well as complete drive systems FEV has demonstrated competence in the development of alternative drive concepts for almost twenty years. Most recently, yet another plug-in hybrid vehicle has gone into series production with technology provided by the Aachen-based developer. In addition to using an innovative transmission concept which is based on a FEV patent, FEV also developed the battery technology of the plug-in hybrid vehicle to series production readiness.

Toyota confirms C-HR crossover to debut at Geneva

With the compact crossover segment booming with new entries, Toyota soon intends to burst into the popular market with a production version of the C-HR concept. The rakishly styled, little CUV will show off its final face at the 2016 Geneva Motor Show next March, and European sales will start before summer, Autocar reports. Customers in the US will likely get to drive the angular model, too. The C-HR concept's chiseled shape is expected to make the transition to the road largely unaltered. According to Autocar, customers reportedly really dig the razor-sharp look versus a more conventional CUV design. A hybrid is also expected to be included in the production powertrain lineup, but non-electrified options could be available, too. The Japanese automaker last displayed the C-HR at this year's Frankfurt Motor Show. Underneath the avant-garde shape, the Toyota New Global Architecture provided the underpinnings, and a hybrid powertrain was there for propulsion. The concept's general design idea was actually the revival of a three-door crossover from the 2014 Paris Motor Show. In addition, the production C-HR is expected eventually to arrive in the US but likely wearing a Scion badge. Spy shots highly suggest that a crossover is already under development, and the entry would give the division a much-needed challenger to the Nissan Juke, Honda HR-V, Mazda CX-3, and plenty of others. Plus, the brand is keeping it absolutely no secret that a third, new model is on way to join the iA and iM.