2021 Toyota Camry Le on 2040-cars

Auto blog

Junkyard Gem: 2010 Pontiac Vibe

Just over a month before filing for Chapter 11 bankruptcy in June 2009, General Motors announced that the 83-year-old Pontiac Division would be "phased out" by the end of 2010. Only three Pontiac vehicles were sold as 2010 models in the United States: the Solstice, Vibe and G6 (new G3s were sold here during 2010 but they were all 2009 models, while the G5 was available as a 2010 model only in Canada and Mexico). Today's bit of junkyard automotive history is one of the very last Vibes ever built, found in a yard near Denver, Colorado. This car is significant not just as one of the final vehicles to bear Pontiac badges but also as one of the last cars built by the New United Motor Manufacturing Incorporated GM-Toyota joint venture in California, better known as NUMMI. The NUMMI factory began life as GM's Fremont Assembly, which built its first vehicle (a C-Series pickup) in 1963 and closed in 1982 after building its final vehicle (an Oldsmobile Cutlass Ciera). Rebooted as NUMMI, the first 1985 Chevrolet Nova (an Americanized AE82 Toyota Corolla Sprinter) rolled off the line in December of 1984. A quarter-century and better than eight million vehicles hence, NUMMI shut down production after its last Corolla was finished on April 1, 2010. While there was some noise about the Oakland Athletics building a new stadium on the site at the time, Tesla ended up buying most of the site soon after that. Tesla now builds more vehicles per year there than NUMMI ever did. The Vibe was co-developed with Toyota and based on the same platform as the ninth-generation Corolla. The Toyota Matrix was mechanically identical and was built in Canada, while the Japanese-market version (known as the Toyota Voltz) was built on the same NUMMI line as the Vibe and shipped across the Pacific. The Vibe/Matrix/Voltz got a redesign for the 2009 model year, but few noticed due to all the turmoil in the GM world at the time. The final Vibe was built in August 2009. This car was built in July of 2009, just before the end. It was living in West Texas just prior to coming to Colorado. El Paso is about a ten-hour drive from this car's current location. Once in the Centennial State, it got parked somewhere it shouldn't have been and ended up being auctioned to Pick Your Part. An occupant of this Vibe had time to sample some of the local agricultural products before that happened.

Toyota recalls 337,000 RAV4s and HS250h models for tie rod failure

UPDATE: The post has been updated with additional information from NHTSA. The Basics: Toyota is recalling 337,000 2006-2011 model year Toyota RAV4 crossovers built between October 31, 2005 and September 7, 2010 as well as 2010 model year Lexus HS250h cars built between July 6, 2009 and August 26, 2010. The Problem: When either an affected RAV4 or HS250h is given an alignment and the tie rod adjustment nut on the rear control arm isn't tightened properly, the threads on the tie rod can start to rust. If this happens, the nut may break off and throw off the alignment drastically and suddenly. This isn't a case of the car simply pulling to one side, either. This would seriously upset the balance of the car and could cause the driver to lose control and crash. This is also the third time these vehicles have been recalled for the same issue. Injuries/Deaths: It's unknown if this control arm issue has resulted in any injuries or deaths. Autoblog reached out to Toyota for more information, but a company representative told us that the company isn't able to discuss injuries or deaths caused by this issue (if any) at this time. Based on information from NHTSA documents, it does not appear that any crashes, injuries or deaths have been attributed to the defect addressed in the current recall. The Fix: The dealer will completely replace the rear suspension assemblies at no cost to the owner. The tie rods and nuts will also be coated in epoxy to prevent future rusting from occurring. According to Car and Driver, the previous recalls involved tightening nuts, coating decent tie rods in epoxy and completely replacing rusted ones. The car magazine reports that further complaints were filed and the company is now replacing all components regardless of condition. If you own one: Toyota will notify owners of affected cars by mail. Owners can also check whether their cars are affected by entering the VIN at safercar.gov/vin. Owners with questions can also reach Toyota customer service at 1-800-331-4331 or Lexus customer service at 1-800-255-3987. Related Video: Featured Gallery 2012 Toyota RAV4 View 16 Photos News Source: Car and Driver, Toyota, National Highway Traffic Safety AdministrationImage Credit: Toyota Recalls Lexus Toyota Safety lexus hs 250h lexus hs250h

HQ move based on study, not pitch from Gov. Perry, Toyota says

Toyota's surprising announcement on Monday that it will move its North American headquarters from Torrance, CA location to the Dallas suburb of Plano, TX is allegedly not due to any political wrangling from the state's Republican governor, Rick Perry.
Perry (above) has been up front in his aggressive pursuit of businesses and jobs for Texas, traveling to California, Missouri, Illinois and New York to tempt corporations to his state. And it's not just about the promise of much lower taxes, a Perry spokesman reminds Automotive News that the state boasts, "a workforce that is skilled and ready to do any job."
For his part, Jim Lentz, Toyota's North American CEO said Plano was chosen through an internal process, with the location helped by its proximity to the company's massive pickup factory in San Antonio rather than any campaigning from the governor.