2013 Toyota 4runner Limited 4wd, 7500 Miles, Navigation, Leather, Heated Seats on 2040-cars

Auto blog

Toyota mulling more Tundra, Tacoma capacity in TX

Toyota may be expanding its pickup truck production at its San Antonio, TX factory following calls from dealers for more Tacoma and Tundra models, according to a new report from Automotive News.
The San Antonio plant is currently able to produce 250,000 trucks on two shifts with overtime, while a secondary facility in Tijuana, Mexico can build an extra 50,000 Tacomas. Despite this capacity, and the fact that Tundra is a slow seller relative to the full-size trucks from Ford, Ram and Chevrolet/GMC (not to mention the Tacoma being part of a segment with diminishing sales), Toyota franchisees apparently can't get enough of the trucks.
"Dealers are telling us they could sell more Tacomas and Tundras," said Bill Fay, the general manager of the Toyota Division. "We are evaluating our footprint and capacity." According to AN, Toyota has moved over 248,000 trucks through November.

Japanese automakers ramping production for renewed American sales

The 2011 earthquake and tsunami that struck Japan took quite the toll on the automotive industry in that nation. Not content to lean on that tragedy as excuse for slagging sales, the Japanese automakers are planning on a major production expansion in North America. The aim is to reclaim the market share lost from the Tsunami-based dip, and overcome a dollar/yen exchange rate that makes exporting to America unprofitable.
Following the Tsunami, Japanese automakers ramped up production in their North American facilities to compensate, but according to Automotive News, Nissan, Honda and others have all reported plans for still-further increased production in the year ahead. As part of this ramp-up, Mazda will open a facility in Salamnca, Mexico before March of 2014. Part of that increase in output is 50,000 units of a Toyota-badged compact car, which Mazda will produce.
Other Mexican production facilities opening include a Honda plant, which will open in Spring 2014 in Celaya, and a Nissan plant, set to open later this year in Aguascalientes. Nissan also said that it will need another plant in North America within the next five years. According to Nissan Boss Carlos Ghosn, the company aims to raise its stake in the US market from 8 percent to 10, and adding production will help achieve that goal. Even Mitsubishi is aiming to boost production at its Normal, Illinois plant. Production of the Outlander Sport is currently at 50,000, which Mitsubishi wants to raise to 70,000.

Toyota recalls 337,000 RAV4s and HS250h models for tie rod failure

UPDATE: The post has been updated with additional information from NHTSA. The Basics: Toyota is recalling 337,000 2006-2011 model year Toyota RAV4 crossovers built between October 31, 2005 and September 7, 2010 as well as 2010 model year Lexus HS250h cars built between July 6, 2009 and August 26, 2010. The Problem: When either an affected RAV4 or HS250h is given an alignment and the tie rod adjustment nut on the rear control arm isn't tightened properly, the threads on the tie rod can start to rust. If this happens, the nut may break off and throw off the alignment drastically and suddenly. This isn't a case of the car simply pulling to one side, either. This would seriously upset the balance of the car and could cause the driver to lose control and crash. This is also the third time these vehicles have been recalled for the same issue. Injuries/Deaths: It's unknown if this control arm issue has resulted in any injuries or deaths. Autoblog reached out to Toyota for more information, but a company representative told us that the company isn't able to discuss injuries or deaths caused by this issue (if any) at this time. Based on information from NHTSA documents, it does not appear that any crashes, injuries or deaths have been attributed to the defect addressed in the current recall. The Fix: The dealer will completely replace the rear suspension assemblies at no cost to the owner. The tie rods and nuts will also be coated in epoxy to prevent future rusting from occurring. According to Car and Driver, the previous recalls involved tightening nuts, coating decent tie rods in epoxy and completely replacing rusted ones. The car magazine reports that further complaints were filed and the company is now replacing all components regardless of condition. If you own one: Toyota will notify owners of affected cars by mail. Owners can also check whether their cars are affected by entering the VIN at safercar.gov/vin. Owners with questions can also reach Toyota customer service at 1-800-331-4331 or Lexus customer service at 1-800-255-3987. Related Video: Featured Gallery 2012 Toyota RAV4 View 16 Photos News Source: Car and Driver, Toyota, National Highway Traffic Safety AdministrationImage Credit: Toyota Recalls Lexus Toyota Safety lexus hs 250h lexus hs250h