2015 Ram Promaster 1500 Standard on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

How to update and secure a vulnerable Chrysler Uconnect system

If you own one of the 1.4 million vehicles affected by the recent Chrysler software recall, you may want to watch this video. In it, we explain how to get the latest infotainment software loaded onto the 8.4-inch Uconnect system. The recall was a response to the findings of researchers who were able to hack into and remotely control a 2014 Jeep Cherokee through its cellular connection. Although Fiat Chrysler has worked with Sprint to plug most of the holes on the carrier side, there are still some vulnerabilities that only this latest software version can patch. Owners have three options to get the update: download it now, wait for a USB stick in the mail, or take the vehicle to an FCA dealer. Chrysler will be sending USB sticks loaded with the software update to customers. Anyone with an internet connection and a USB stick of their own with at least 4 GB capacity can speed things up by downloading the patch from the Uconnect website. We cover that process from start to finish in the video, with the final portion still applicable to those using the FCA-supplied USB stick. If after watching this you still don't want to tackle the patch yourself, you can take your vehicle to the dealer to have it done. Also note that this process is the same for all Uconnect updates, not just the one patching the exploits. Our demonstrator vehicle is a 2015 Ram 1500 pickup. The procedure should be very similar on other products with the 8.4-inch Uconnect system, with only the location of the USB port varying. Once you have the USB stick with the software on it – either after having downloaded it yourself or receiving it in the mail from Chrysler – the installation process is relatively simple. It takes about 15 minutes to perform the update; we edited out the wait in the video. To check whether or not your car's 8.4-inch Uconnect system is running the latest software, go to System Information on the touch screen's Settings page and look at Software Version. The update related to the recall is version 15.17.5. Related Video: Recalls Chrysler Dodge Jeep RAM Safety Technology Infotainment Videos Original Video hacking

FCA CEO Mike Manley will run Americas for Stellantis after PSA merger

DETROIT — Fiat Chrysler CEO Mike Manley will run operations in the Americas when his company merges with FranceÂ’s PSA Peugeot early next year. FCA Chairman John Elkann announced ManleyÂ’s new post on Friday in a letter to employees. ManleyÂ’s role in the merged company had been a mystery. PSA CEO Carlos Tavares will run the overall company, to be named Stellantis. Shareholders of both companies will vote on the merger Jan. 4 to seal the deal creating the worldÂ’s fourth-largest automaker. The merger is expected to be completed by the end of March. PSA will get six seats on the new companyÂ’s 11-member board, which will be chaired by Elkann. The Americas, especially the U.S., are key to the new companyÂ’s success. Fiat ChryslerÂ’s Jeep and Ram brands are highly profitable, and Tavares has long wanted to sell PSA vehicles in the U.S. Manley has been the Italian-American automakerÂ’s CEO for 2 1/2 years, taking over when Sergio Marchionne died in 2018. Stellantis will have the capacity to produce 8.7 million cars a year, just behind Volkswagen, the Renault-Nissan alliance and Toyota. Related Video: Hirings/Firings/Layoffs Chrysler Dodge Fiat Jeep RAM Citroen Peugeot Mike Manley Stellantis