2019 Ram 5500 Chassis Cab Tradesman 4x4 Diesel Knapheide Service Bed Aisin D on 2040-cars
Mansfield, Texas, United States
For Sale By:Dealer
Transmission:Automatic
Vehicle Title:Clean
VIN (Vehicle Identification Number): 3C7WRNFLXKG574881
Mileage: 220627
Drive Type: Four Wheel Drive
Exterior Color: White
Interior Color: Gray
Make: Ram
Manufacturer Exterior Color: Bright White Clearcoat
Manufacturer Interior Color: Diesel Gray/Black
Model: 5500 Chassis Cab
Number of Doors: 4 Doors
Trim: Tradesman 4x4 Diesel Knapheide Service Bed Aisin D
Ram 5500 Chassis Cab for Sale
Auto Services in Texas
Zoil Lube ★★★★★
Young Chevrolet ★★★★★
Yhs Automotive Service Center ★★★★★
Woodlake Motors ★★★★★
Winwood Motor Co ★★★★★
Wayne`s Car Care Inc ★★★★★
Auto blog
Ram recalling 65k trucks for rear-axle heat treating
Tue, Oct 27 2015A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.
Four Wheeler crowns Ultimate Factory 4x4... who wins?
Thu, 15 Nov 2012Nearly every automaker doing business in the SUV or pickup truck segments offers a package designed to improve the off-road capabilities of its wares. But, of course, not all such factory kits are created equal. How, then, to separate the wheat from the chaff? Gather each of them up and put them through their paces, naturally.
The folks from Four Wheeler and PickupTrucks.com joined forces to run just such a comparison test, with the winner named the Ultimate Factory 4x4. A total of seven vehicles showed up to the fight: the 2012 Ford F-150 SVT Raptor, 2013 Jeep Wrangler Rubicon, 2012 Nissan Frontier PRO-4X and Xterra PRO-4X, 2012 Ram Power Wagon, and 2012 Toyota 4Runner Trail and Tacoma TRD T|X Baja Series.
With the contestants in place, the whole crew put each vehicle through a battery of tests that included skidpad and acceleration measurements, a hillclimb, a rocky stairstep course and a rock garden. Considering the nature of the beasts, on-road ride and comfort were not part of the routine.
FCA CEO Mike Manley will run Americas for Stellantis after PSA merger
Sun, Dec 20 2020DETROIT — Fiat Chrysler CEO Mike Manley will run operations in the Americas when his company merges with FranceÂ’s PSA Peugeot early next year. FCA Chairman John Elkann announced ManleyÂ’s new post on Friday in a letter to employees. ManleyÂ’s role in the merged company had been a mystery. PSA CEO Carlos Tavares will run the overall company, to be named Stellantis. Shareholders of both companies will vote on the merger Jan. 4 to seal the deal creating the worldÂ’s fourth-largest automaker. The merger is expected to be completed by the end of March. PSA will get six seats on the new companyÂ’s 11-member board, which will be chaired by Elkann. The Americas, especially the U.S., are key to the new companyÂ’s success. Fiat ChryslerÂ’s Jeep and Ram brands are highly profitable, and Tavares has long wanted to sell PSA vehicles in the U.S. Manley has been the Italian-American automakerÂ’s CEO for 2 1/2 years, taking over when Sergio Marchionne died in 2018. Stellantis will have the capacity to produce 8.7 million cars a year, just behind Volkswagen, the Renault-Nissan alliance and Toyota. Related Video: Hirings/Firings/Layoffs Chrysler Dodge Fiat Jeep RAM Citroen Peugeot Mike Manley Stellantis