2021 Ram 3500 Limited Mega Cab Custom on 2040-cars

Auto blog

2014 Ram Promaster recalled over stuck pedal fears

Ram's new, Fiat-derived cargo van, the ProMaster, is set to be recalled over concerns that the accelerator pedals could stick. The issue affects 9,655 ProMasters, with 7,935 vans in the US, 1,437 vehicles in Canada and 283 in Mexico.
There have been no reported injuries or crashes from the issue - according to The Detroit News, there haven't even been any customer complaints. The issue was reportedly discovered while Chrysler was testing the vehicle at its proving ground, which is what prompted the internal investigation. Still, it's unlikely that ProMaster vans will suffer from unintended acceleration issues, as each van is equipped with a brake-throttle override.
As of this writing, there's been no bulletin or activity from the National Highway Traffic Safety Administration.

2014 Ram ProMaster 2500

Front-wheel drive is what sets the all-new Ram ProMaster full-size commercial van apart from its competition. In a segment still choked with thirsty, rear-wheel-drive, ladder frame, pickup truck-based cargo vans, the American automaker is introducing something entirely new - well, new to our domestic market, as Europeans will recognize Ram's fresh entrant as a made-for-USA Fiat Ducato.
While the big ProMaster doesn't have a traditional body-on-frame chassis, it isn't a pure unibody either. Consider it a hybrid of both, with a unibody cab up front and a reinforced high-strength steel subframe in the rear. The platform employs double A-arms and MacPherson struts on the front axle, while the rear uses a simple tubular beam axle. Tires are 225/75R16 at all four corners. The steering is hydraulic rack-and-pinion (allowing an impressive 36-foot turning radius) and there are disc brakes with two-piston calipers all around. It is a solid, if unsophisticated, setup.
This game-changing van, which has already arrived in showrooms with a starting price of $28,630, is propelled by either a gasoline-powered 3.6-liter Pentastar six-cylinder (280 horsepower and 258 pound-feet of torque) or a new turbocharged 3.0-liter four-cylinder diesel (174 horsepower and 295 pound-feet of torque). Ram will offer a traditional six-speed automatic or a new six-speed automated single-clutch manual transmission that drops the hydraulic linkage to improve fuel economy - details are still emerging on this unique gearbox.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.