2025 Ram 1500 Big Horn/lone Star on 2040-cars

Auto blog

Analysts wary over FCA lawsuit but say emissions not as bad as VW

MILAN - Any potential fines Fiat Chrysler (FCA) may need to pay to settle a US civil lawsuit over diesel emissions will unlikely top $1 billion, analysts said, adding the case appeared less serious than at larger rival Volkswagen. The US government filed a civil lawsuit on Tuesday accusing FCA of illegally using software to bypass emission controls in 104,000 vehicles sold since 2014, which it said led to higher than allowable levels of nitrogen oxide (NOx) that are blamed for respiratory illnesses. FCA's shares dropped 16 percent in January when the U.S. Environmental Protection Agency (EPA) first raised the accusations, adding the carmaker could face a maximum fine of about $4.6 billion. The stock has been under pressure since. Volkswagen agreed to spend up to $25 billion in the United States to address claims from owners, environmental regulators, U.S. states and dealers. FCA, which sits on net debt of 5.1 billion euros ($5.70 billion), lacks VW's cash pile but analysts said its case looked much less severe. While VW admitted to intentionally cheating, Fiat Chrysler denies any wrongdoing. Authorities will have to prove that FCA's software constitutes a so-called "defeat device" and that it was fitted in the vehicles purposefully to bypass emission controls. Even if found guilty, the number of FCA vehicles targeted by the lawsuit is less than a fifth of those in the VW case. Applying calculations used in the German settlement, analysts estimate potential civil and criminal charges for Fiat Chrysler of around $800 million at most. Barclays has already cut its target price on the stock to take such a figure into account. Analysts also noted that FCA's vehicles are equipped with selective catalytic reduction (SCR) systems for cutting NOx emissions, so it is likely that any problem could be fixed through a software update. "Should this be the case, we estimate a total cost per vehicle of not more than around $100, i.e. around $10 million in aggregate," Evercore ISI analyst George Galliers said in a note. The estimates exclude any additional investments FCA may be asked to make in zero emissions vehicles infrastructure and awareness as was the case with VW. FCA said last week it would update the software in the vehicles in question, hoping it would alleviate the regulators' concern, but analysts said it may have been too little too late. The carmaker is also facing accusations over its diesel emissions in Europe.

A beginner's guide to plowing snow with a heavy-duty truck

I live in a desert, so the only things getting plowed around here are mud flows and brewer neighbors. But I enjoy machinery and haven't plowed any snow since a "loaded" truck meant one with A/C and a CD player, so I jumped at the chance for a plow primer in a Ram HD on a Canadian airfield. Running a plow is like welding – the basics come quickly but experience pays dividends. The first thing to deal with is a frequently changing horizon because, stout as they are, even three-quarter-ton heavy-duty trucks will move up and down in front considerably with a 600-to-800-pound plow hanging off, and fast plow hydraulics rival some low-riders for bounce effect. Getting going is easy unless you forgot blocks and the plow froze to the ground, rookie. If you have to drive to your plowing assignment, blade height needs some experimentation to find the best cooling airflow; if you think sub-freezing temperatures negate that concern, remember you've installed what amounts to a 20-square-foot air brake up front that the truck has to overcome, and blowing snow could block some cooling air passages. Whether it's a "straight" blade or V design, always have it tilted to the right lest you catch a hidden post, solid mailbox, or edge of a snow bank. Most plow operators I spoke to rarely exceed 45 mph in transit because of cooling, front suspension travel, and common sense, and you should go even slower if you don't have some ballast like chains, extra fuel tanks, or a salt spreader to balance the load on the back. With trucks' relatively slow steering and all that weight up high, oversteer is best avoided. With a little clean space to get a run, stick it in Drive to gather momentum and lower the plow simultaneously to float, where the weight of the plow rests on and lets it run along the surface. Momentum is good until you hit something you didn't know about, at which point the plow's breakaway systems limit damage but your truck could still hit something big; caution never hurts. Start out at 10 to 15 mph, depending on consistency and depth, making a clean wave off one side. If you have to push it straight, as you slow coincidentally raise the blade at the bottom of the pile to shove it up higher. Carry too much speed here and you'll stop with an unceremonious thud. Common mistakes cited among a few experts were people pushing banks of snow rather than plowing it, and rushing the shift between Drive and Reverse, throttling up before the shift is completed.

Dodge, Jeep and Ram could soon be owned by Chinese automakers

For the past several years, Fiat Chrysler CEO Sergio Marchionne has made it widely known that the automaker he helms is up for grabs. First, he sent an email to GM CEO Mary Barra, who immediately refused to even discuss a merger. Later, Marchionne set his sights on Volkswagen. That too was swiftly rebuffed. It seemed like no global automaker was remotely interested in a partnership. Now, Automotive News reports that several Chinese automakers have come calling, only FCA isn't ready to answer. At least not yet. The news broke this morning that a major Chinese automaker had made an offer to purchase FCA for slightly above market value. FCA refused, saying the offer wasn't quite generous enough. It's unclear which automaker made the offer, but Automotive News says there's more than one interested party. FCA representatives have recently traveled to China to meet with Great Wall Motors, while Chinese representatives were seen at FCA corporate headquarters in Auburn Hills, Mich. The Chinese government has a lot of money invested in local automakers. It's putting pressure on these automakers to expand globally, including to the United States. As it stands, it's a matter of when a Chinese automaker will start selling cars here, not if. Purchasing an established automaker with a wide range of products and a huge dealer network would do wonders in giving the Chinese a foothold here. Sure, Geely owns Volvo, but a luxury automaker doesn't have nearly as much reach as a more mainstream company like FCA. This seems like the best case scenario for both a Chinese automaker looking to move into the U.S. and for FCA, at least from a business standpoint. The latter doesn't seem to have any other interested parties. It will be interesting to see how FCA would sell a deal like this to the public. We're not sure everyone will be happy with Dodge, Jeep and Ram falling under Chinese ownership. FCA didn't turn down the Chinese because they didn't like the idea. It turned down the offer because there wasn't enough money on the table. Related Video: News Source: Automotive News Earnings/Financials Alfa Romeo Chrysler Dodge Fiat Jeep RAM