2022 Ram 1500 Laramie on 2040-cars

Auto blog

Pickup sales may hit 2M units for first time since 2007

Even as fuel prices creep back up, trucks are still a hot item among new-vehicle shoppers. To see how popular pickup trucks still are, you don't have to look any further than how much effort automakers put into the continual one-upmanship of their trucks. Backing this fact up, USA Today is reporting that the segment could top two million sales this year - a total not matched since 2007, though still far from the pre-recession, three-million-unit levels.
Through August, the Ford F-Series continues to be the segment leader with almost 500,000 units sold, but the Chevy Silverado (328,269), Ram 1500 (234,642), GMC Sierra (122,232) and Toyota Tacoma (110,293) are all seeing at least 20-percent sales increases, helping to account for around 1.44 million truck sales so far this year - not including possible outliers like the Suzuki Equator and Chevy Avalanche.
This year alone, General Motors has completely redesigned its fullsize trucks, Ram and Toyota have significantly updated their offerings, the next-gen Ford F-150 will be out next year and Nissan is promising an all-new Titan around the same time with an eventual Cummins diesel under the hood. It would seem, then, that truck sales are poised to continue their upward trend.

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Ram trucks set for export to Australia, New Zealand

Looking across the Pacific at Australia's car-based utes is always a little exciting because it's a glimpse at a land where models not unlike the classic Chevrolet El Camino survive. Now, the Aussies are about to see how the US builds big trucks thanks to a deal to import the Ram 2500 and 3500 into the country. This new market entry comes about thanks to a deal between Ram and the New Zealand importer of FCA products, and once across the ocean, the trucks are converted to right-hand drive. The automaker has "worked closely with our engineers to produce a vehicle that is as close to an official factory right-hand-drive vehicle as it can be without it having actually run down the factory production line," Clyde Campbell, co-owner of Fiat Chrysler New Zealand," said to Drive. The first batch of pickups is set to go on sale to Kiwis and Aussies in October, but further details about them aren't disclosed yet, including available powertrains and price. Drive estimates the Ram 3500 to retail for over 100,000 Australian dollars ($76,000). The trucks are being aimed at those with heavy loads to haul like industrial companies or people with large horse trailers. These might not be the last two Ram models to make it Down Under, either. According to Drive, the New Zealand importer is working to strike a similar deal to bring the Ram 1500 across the Pacific in the future.