2014 Ram 1500 Tradesman/express on 2040-cars

Auto blog

A beginner's guide to plowing snow with a heavy-duty truck

I live in a desert, so the only things getting plowed around here are mud flows and brewer neighbors. But I enjoy machinery and haven't plowed any snow since a "loaded" truck meant one with A/C and a CD player, so I jumped at the chance for a plow primer in a Ram HD on a Canadian airfield. Running a plow is like welding – the basics come quickly but experience pays dividends. The first thing to deal with is a frequently changing horizon because, stout as they are, even three-quarter-ton heavy-duty trucks will move up and down in front considerably with a 600-to-800-pound plow hanging off, and fast plow hydraulics rival some low-riders for bounce effect. Getting going is easy unless you forgot blocks and the plow froze to the ground, rookie. If you have to drive to your plowing assignment, blade height needs some experimentation to find the best cooling airflow; if you think sub-freezing temperatures negate that concern, remember you've installed what amounts to a 20-square-foot air brake up front that the truck has to overcome, and blowing snow could block some cooling air passages. Whether it's a "straight" blade or V design, always have it tilted to the right lest you catch a hidden post, solid mailbox, or edge of a snow bank. Most plow operators I spoke to rarely exceed 45 mph in transit because of cooling, front suspension travel, and common sense, and you should go even slower if you don't have some ballast like chains, extra fuel tanks, or a salt spreader to balance the load on the back. With trucks' relatively slow steering and all that weight up high, oversteer is best avoided. With a little clean space to get a run, stick it in Drive to gather momentum and lower the plow simultaneously to float, where the weight of the plow rests on and lets it run along the surface. Momentum is good until you hit something you didn't know about, at which point the plow's breakaway systems limit damage but your truck could still hit something big; caution never hurts. Start out at 10 to 15 mph, depending on consistency and depth, making a clean wave off one side. If you have to push it straight, as you slow coincidentally raise the blade at the bottom of the pile to shove it up higher. Carry too much speed here and you'll stop with an unceremonious thud. Common mistakes cited among a few experts were people pushing banks of snow rather than plowing it, and rushing the shift between Drive and Reverse, throttling up before the shift is completed.

Chevy Silverado edges Ram 1500 in Consumer Reports two-truck shootout

Forget Corvette versus Viper. When it comes to important head-to-head comparisons, fullsize trucks are where domestic automakers really care. And until the redesigned Ford F-150 makes its debut, the Chevrolet Silverado is going to have plenty to brag about thanks to a new Consumer Reports shootout against the Ram 1500.
It was a tight race among these V8-powered titans, but the all-new 2014 Silverado (and its GMC Sierra twin) barely edged out Ram's updated pickup with a score of 81 points - enough to make it the institute's top-rated fullsize truck on the market. Its narrow victory over the Ram, which finished just three points back, was due to its superior fuel economy, better towing and payload capacity and conveniences like a lower step-in height, easy-to-use tailgate and rear bumper steps that make loading and unloading less of a chore.
Importantly, CR notes that buyers with less heavy-duty truck needs might actually prefer the Ram over the Chevrolet, since its high points include a smoother ride thanks to its coil spring rear suspension, dominant infotainment system with Uconnect, and a big thumbs up for the available Hemi engine and eight-speed automatic transmission.

Chrysler earns $1.7B in 2012, revises product plans for US

Hot on the heels of Ford's earnings announcement for the year that was, Chrysler today reported a 2012 net income of $1.7 billion, up substantially from the comparatively minuscule $183 million profit earned in 2011 when it repaid its US government loans.
Chrysler's good year ended with an excellent fourth quarter that saw net income rise 68 percent from $225 million in 2011 to $378 million. Where are all those extra earnings coming from? Market share, which Chrysler saw increase to 11.4% last year on sales of 1.65 million vehicles. In fact, the Auburn Hills, MI-based automaker out-paced the industry's market growth of 13 percent last year with sales up 21 percent for the year.
The company also revealed an updated product plan for its Chrysler Group and Fiat brands that looks all the way out to 2016. It's an updated version of the plan introduced in 2009 shortly after Fiat took control of the American automaker, and includes such new additions as an Alfa Romeo model, likely the 4C, to be introduced in the US this year, as well five more Alfa models by 2016. Likewise, Fiat will be growing by an additional seven models in the coming few years.