1999 Pontiac Grand Am Gt Sedan 4-door 3.4l Black on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Junkyard Gem: 1992 Pontiac Firebird

Last spring, this series featured a 1992 Chevrolet Camaro RS in a Northern California junkyard, an example of the final model year for the highly successful third-generation GM F-Body. On a later visit to that yard, I spotted the Pontiac sibling to that car, a Firebird that was born the same year at the same Southern California factory. When the Chevrolet Division introduced the first Camaro as a 1967 model, the Pontiac Division got its own version of the F-Body called the Firebird. While the two cars were built on the same chassis and looked very similar, the first-generation Camaros got Chevrolet engines while their Firebird colleagues got Pontiac engines (including the innovative SOHC straight-six). The 1970-1981 second-generation Firebirds still had some Pontiac-only engines, but Chevrolet and Oldsmobile power crept under some hoods during that period. The third-generation Firebirds first appeared as 1982 models, and they drew from near-identical stockpiles of GM running gear (including the distinctly agricultural Iron Duke four-banger, which could be considered a Pontiac-derived engine). When the Camaro got the axe after 2002, the Firebird's neck was put on the same chopping block. When the Camaro returned for 2010, the Pontiac brand was sputtering to an agonized halt during its final year and there was no chance of the Firebird's return. This car is a fairly ordinary coupe, though it does have the mid-grade 205-horsepower 5.0-liter Chevrolet small-block V8 instead of the base 140-horse 3.1-liter V6. A 5.7-liter small-block was available as well. A five-speed manual transmission was base equipment, but few Americans wanted a three-pedal setup by the early 1990s. This car has the optional four-speed automatic. The MSRP with 5.0 engine, automatic transmission and air conditioning (which this car has) started at $14,304. That's about $31,868 in 2023 dollars. It was built at Van Nuys Assembly in the San Fernando Valley of Los Angeles County. By the dawn of the 1990s, the Camaros and Firebirds made at Van Nuys Assembly had become known as the worst-built GM cars made in North America, and the plant was shut down forever soon after this car was built. Today, a shopping mall lives where the factory once stood. This car managed to drive more than 150,000 miles during its life, so it beat the odds. The thrid-gen F-Body was pretty antiquated by the early 1990s, but the fourth-gen cars handled better and looked up-to-date for the era.

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.