Museum Quality 1965 Pontiac Gto 389 Tri-power 4 Spd Manual Top Notch Restoration on 2040-cars

Auto blog

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.

This or That: 2005 Chrysler Crossfire SRT6 vs. 1984 Pontiac Fiero

Welcome to another round of This or That, where two Autoblog editors pick a topic, pick a side and pull no punches. Last round pitted yours truly against Associate Editor Brandon Turkus, and my chosen VW Vanagon Syncro narrowly defeated Brandon's 1987 Land Rover. In fact, it was, by far, the closest round we've seen, with 1,907 voters seeing things my way (for 50.8 percent of the vote) versus 1,848 votes for Brandon's Rover (49.2 percent). Sweet, sweet victory! For this latest round of This or That, I've roped Editor Greg Migliore into what I think is a rather fun debate. We've each chosen our favorite terrible cars, setting a price limit of $10,000 to make sure neither of us went too crazy with our automotive atrocities. I think we've both chosen terribly... and I mean that in the best way possible. 2005 Chrysler Crossfire SRT6 Jeremy Korzeniewski: Why It's Terrible: Taken in isolation, the Chrysler Crossfire isn't necessarily a terrible car. In fact, it drives pretty darn well, and there's a lot of solid engineering under its slinky shape. Problem is, that engineering was already rather long in the tooth well before Chrysler ever got its hands on it, having come from Mercedes-Benz, which used the basic chassis and drivetrain in a previous version of its SLK coupe and roadster. Granted, the SLK was an okay car, too, but even when new, it hardly set the world on fire with sporty driving dynamics. Chrysler took these decent-but-no-more bits and pieces from the Mercedes parts bin – remember, this car was conceived in the disastrous Merger Of Equals days – and covered them with a rather attractive hard-candy shell. Unfortunately, the super sporty shape wrote checks in the minds of buyers that its well-worn mechanicals were simply unable to cash, though an injection of power courtesy of a supercharged V6 engine in the SRT6 model, as seen here, certainly helped ease some of those woes. In the end, Chrysler was left with a so-called halo car that looked the part but never quite performed the part. It was almost universally panned by critics as an overpriced parts-bin special, which, I must add, was damningly accurate. As a result, sales were very slow, and within the first few months, dealers were clearancing the car at cut-rate prices, just to keep them from taking up too much of the showroom floor. Why It's Not That Terrible, After All: I can speak from personal experience when discussing the Chrysler Crossfire. You see, I owned one. Well, sort of...

Junkyard Gem: 1989 Pontiac 6000 STE AWD

During the middle to late 1980s, General Motors made a big push to grab back some of the sales swiped by makers of European luxury machinery during the previous decade. Around the top of the prestige pyramid, there was the Turin/Hamtramck-built Cadillac Allante taking aim at the Mercedes-Benz 560SEC and the super high-tech Buick Reatta trying to seduce away BMW and Jaguar shoppers; even the Riviera offered a futuristic touchscreen computer sorely lacking in anything out of Stuttgart or Bavaria. The General had a plan to take on the smaller German sporty sedans, too, and Pontiac of the "We Build Excitement" era offered a midsize sedan packed with modern hardware at a great price: the 6000 STE. Here's one of the rarest 6000 STEs of them all, an all-wheel-drive-equipped '89 found in a Denver-area yard last week. Any 6000 STE is extremely hard to find today; when I wrote about a front-wheel-drive 1987 6000 STE back in 2018, desperate owners of these cars filled my inbox with requests — sometimes demands —  for parts that continue to this day. Many of them pleaded with me to help them find an all-wheel-drive version, and now I have managed to find one at Colorado Auto & Parts in Englewood, just south of Denver (in fact, the same yard at which I shot the '87). You may recall CAP as the old-school yard whose owners built the amazing airplane-engined 1939 Plymouth pickup a few years back.  The all-wheel-drive system on the 6000 STE was introduced for the 1988 model year, and it became standard equipment on the 1989 STE. At this time, the automotive industry had taken note of the success of the idiot-proof all-wheel-drive systems offered by AMC and Audi/Volkswagen; Toyota began selling Americans all-wheel-drive Camrys, Celicas, and Corollas, while Ford offered the Tempo and Topaz with optional AWD and Subaru was just beginning to make the switch from manually-selected four-wheel-drive to genuine all-wheel-drive around that time (it took a few more years for everyone to standardize on the 4WD/AWD terminology we use today, though). The 6000 STE AWD was intended to compete with such all-wheel-drive-equipped sedans as the Audi 80 ($23,610), Audi 90 ($28,840), and BMW 325iX ($30,750); its $22,599 price tag (about $50,700 in 2021 dollars) certainly made it seem like a bargain compared to those cars. In addition to the all-wheel-drive system, 1989 6000 STE owners got a digital instrument panel and more switches and buttons than the Space Shuttle.