2006 Pontiac Gto Base Coupe 2-door 6.0l Ls2 Low Miles!!!! Excellent Condition on 2040-cars

Auto blog

AMC Trans Am Javelin SST, an ultra-rare underdog, is up for auction

Among the rarest of the American muscle cars that went racing in the early Seventies — cars including the Camaro Z/28 and the Boss 302 Mustang — the 1970 AMC Trans Am Javelin SST may be the most hard to find, and among the most valuable. Only 100 units of this unique Javelin were produced, and one of them is up for auction at the Mecum event in Dallas on September 20. The Trans Am Javelin was fashioned in a patriotic livery of tricolor paint — red, white and blue — and arrived after the American Motors Corporation had decided in 1968 to compete in the Trans Am racing series against Ford and General Motors. The company's chief driver, Mark Donohue, would dominate the 1971 season, taking seven wins in his Javelin AMX and that yearÂ’s SCCA Trans-Am Championship. AMC took the trophy with 82 points, well ahead of Ford's 61, Chevrolet's 17 and Pontiac's paltry 7. The example listed for auction came equipped with a 390-cubic-inch V-8 engine with 325 horsepower at 5,000 rpm and 420 pound-feet of torque, power steering and brakes, dual exhaust, BorgWarner four-speed manual transmission and Hurst competition shifter. Its “ram induction system” sealed a chamber around the air filter so that cool air from the functional hood scoop would be funneled into the intake. This JavÂ’s factory price was $3,995 — a mere $32,000 or so in today's money, though it was expensive by the standards of the time. The 100 Trans Ams were among 19,714 Javelin units built in 1970, so they started out rare, and today the surviving examples are highly collectible, if and when they come up for sale. No bid estimate is available yet. Related Video: Motorsports Chevrolet Ford Pontiac Auctions Automotive History Racing Vehicles Classics

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.

This classic Firebird restomod swallowed a Prius

It takes an unusual eye to look at a 1967 Pontiac Firebird and see the Toyota Prius hidden inside. But that's just the kind of eye that a creative mechanic known online as "Bill the Engineer" has. Bill is updating his old Firebird into a true classic for the 21st century and has documenting the changes over at Priuschat and EcoModder. The TL,DR version of the story: he's replacing the worn-out powertrain with the gas-electric hybrid one from a Prius V, because it turns out the two vehicles have almost exactly the same wheelbase. Bill, who's from Columbus, Ohio and doesn't want his full name used, said in his posts on the conversion project that he's made many memories with this vehicle since buying it back in 1979. Since then, a few moves, a few decades, and some time in storage meant that the car would no longer function as he wanted it to. As he wrote, "when it comes to mice in the vehicles IT IS WAR." His solution is to make new memories and making a greener vehicle, and so we wanted to ask him how things have been going. Bill's been traveling a bit recently, but told AutoblogGreen that he's now figuring out the next steps for this amazing and complicated project. "I always plan things out before I do them," he said. That's the only way something like this can work. ABG: I think we have to start with what gave you the inspiration for this project. Was it simply that you had the two cars and wanted to see them merged into one cool mashup, or was it something else? "One day my wife wondered out loud if the car could be converted into a hybrid... The rest is history." Bill: I have been the owner of my 1967 Firebird convertible since 1979 when I bought it for $750.00. I drove it for years and made many memories. Afterward it was in storage for many years during which time mice at their way into the car and trashed the interior and wiring. I started working on a conventional restoration but always ran into major problems with hidden corrosion, electrical issues and an engine on its last legs. The car was never going to be as nice as I wanted going the conventional route. One day my wife wondered out loud if the car could be converted into a hybrid like our two daily driver Prii. That got me thinking about how it could be done. The rest is history... ABG: It looks like you started in late 2014. Have things gone well since then, or has it been one hassle after another? What has been the biggest setback, and what were the biggest victories?