Red Firehawk No. 256 Of 500 Built In 1994 - Very Low Miles - One Owner - on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Fiero-based Zimmer Quicksilver was objectively terrible, but we'd totally drive it

Now here's something you don't see everyday. It's listed in our classified ads as a 1986 Pontiac Fiero, but as you can see, that description is a bit misleading. In fact, it's a Zimmer Quicksilver, which was indeed built atop the guts of a mid-engine Fiero coupe but was heavily modified by the Zimmer Motorcars Corporation at a facility in Pompano Beach, Florida. And the one you see here actually seems to be a pretty decent deal for a highly unusual car. We're not sure what was a more popular starting point for kit and custom cars in the 1980s and 1990s, but it would have to be either the Fiero or the vintage air-cooled Volkswagen Beetle. Fiero-based machines usually mimicked the design direction of any number of highly desirable Italian stallions, most commonly, we'd guess, the Lamborghini Countach. The Quicksilver is an altogether different animal, with over a foot of extra wheelbase added in front of the A-pillar to make for a dramatic, long and low silhouette that somehow still only has barely enough room for two passengers in its leather- and wood-lined interior. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. A stock 2.8-liter V6 engine from General Motors is mated to a three-speed automatic transmission that sends 140 horsepower and 170 pound-feet of torque to the rear wheels. Period road tests found the 0-60 run took a little over 10 seconds, which is terrible today but wasn't all that bad for the mid '80s. Best we can tell, only around 170 Quicksilvers were made between 1984 and 1988, which are, not coincidentally, the same years that Pontiac produced the Fiero. The 1986 Zimmer Quicksilver you see here is priced at $18,495 and shows well under 30,000 miles on the odometer. There aren't a lot of Zimmer Quicksilvers currently for sale for us to compare, but the ones we did find that had sold within the last few years suggest a little under $20,000 is a reasonable asking price. It could be a fun and offbeat addition to the garage, and if nothing else, you're not likely to see another one at your local car show. Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.