1975 Pontiac Firebird on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Why Pontiac should come back and how it can be relevant again

When I was a kid growing up in Metro Detroit, our family was always entwined in the General Motors empire. My dad and some of our relatives worked for GM in various capacities, and we had our fair share of Chevrolet, GMC, and even Buick products in our humble driveway. However, it was my Uncle Ed that always had a vehicle from the one GM brand that always appealed to me the most: Pontiac. Seeing him pull up in his Pontiac 6000 and later the '90s era Grand Prix sedan that replaced it was always an exciting occasion, and both of these models also reflected the playful spirit that once defined the Pontiac brand. Back when Pontiac first got its performance groove on in the '60s, names such as GTO, Firebird, as well as Bonneville became iconic nameplates in the broader muscle car era. The '80s saw Pontiac lose some of its styling heritage, but also try new things at the same time including turbocharging as well as the mid-engine sports car with the flawed but still sleek Pontiac Fiero. When the Pontiac brand was shuttered in 2009, it was a mere few years after I earned my drivers license, and also when Pontiac was just beginning to regain some of its lost luster. Granted cookie cutter efforts like the Pontiac G3, (Chevrolet Aveo) G5, (Chevrolet Cobalt) and G6 (Chevrolet Malibu) certainly did not help matters during Pontiac's final years on the market, but two models in particular offered a compelling glimpse into what could've been for the storied brand. The first was the Pontiac Solstice roadster/coupe. Originally introduced as a concept back in 2004, and championed by everyone's fighter jet flying auto executive Bob Lutz, the Solstice was designed to be a serious competitor to the Mazda Miata, and while its interior ergonomics were flawed and the top solution not ideal. It proved to be a fun little car to drive, and also a sales success for Pontiac with initial demand exceeding expectations.This was especially due to its lineup of engines with the 2.0 liter LHU turbocharged four-cylinder engine delivering 260 horsepower in GXP variants. The second and (inarguably my favorite Pontiac model) was the Pontiac G8 sedan. Originating in Australia as the Holden Commodore VE, the G8 was designed to rectify the multitude of sins created by the last generation Bonneville. Front wheel drive was pitched in favor of rear wheel drive, and for the first time in a long time interior ergonomics and cladding free exterior styling were key building blocks for success.

Junkyard Gem: 1989 Pontiac 6000 STE AWD

During the middle to late 1980s, General Motors made a big push to grab back some of the sales swiped by makers of European luxury machinery during the previous decade. Around the top of the prestige pyramid, there was the Turin/Hamtramck-built Cadillac Allante taking aim at the Mercedes-Benz 560SEC and the super high-tech Buick Reatta trying to seduce away BMW and Jaguar shoppers; even the Riviera offered a futuristic touchscreen computer sorely lacking in anything out of Stuttgart or Bavaria. The General had a plan to take on the smaller German sporty sedans, too, and Pontiac of the "We Build Excitement" era offered a midsize sedan packed with modern hardware at a great price: the 6000 STE. Here's one of the rarest 6000 STEs of them all, an all-wheel-drive-equipped '89 found in a Denver-area yard last week. Any 6000 STE is extremely hard to find today; when I wrote about a front-wheel-drive 1987 6000 STE back in 2018, desperate owners of these cars filled my inbox with requests — sometimes demands —  for parts that continue to this day. Many of them pleaded with me to help them find an all-wheel-drive version, and now I have managed to find one at Colorado Auto & Parts in Englewood, just south of Denver (in fact, the same yard at which I shot the '87). You may recall CAP as the old-school yard whose owners built the amazing airplane-engined 1939 Plymouth pickup a few years back.  The all-wheel-drive system on the 6000 STE was introduced for the 1988 model year, and it became standard equipment on the 1989 STE. At this time, the automotive industry had taken note of the success of the idiot-proof all-wheel-drive systems offered by AMC and Audi/Volkswagen; Toyota began selling Americans all-wheel-drive Camrys, Celicas, and Corollas, while Ford offered the Tempo and Topaz with optional AWD and Subaru was just beginning to make the switch from manually-selected four-wheel-drive to genuine all-wheel-drive around that time (it took a few more years for everyone to standardize on the 4WD/AWD terminology we use today, though). The 6000 STE AWD was intended to compete with such all-wheel-drive-equipped sedans as the Audi 80 ($23,610), Audi 90 ($28,840), and BMW 325iX ($30,750); its $22,599 price tag (about $50,700 in 2021 dollars) certainly made it seem like a bargain compared to those cars. In addition to the all-wheel-drive system, 1989 6000 STE owners got a digital instrument panel and more switches and buttons than the Space Shuttle.