1969 Pontiac Firebird Base Hardtop 2-door 5.7l on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.

Junkyard Gem: 1989 Pontiac 6000 STE AWD

During the middle to late 1980s, General Motors made a big push to grab back some of the sales swiped by makers of European luxury machinery during the previous decade. Around the top of the prestige pyramid, there was the Turin/Hamtramck-built Cadillac Allante taking aim at the Mercedes-Benz 560SEC and the super high-tech Buick Reatta trying to seduce away BMW and Jaguar shoppers; even the Riviera offered a futuristic touchscreen computer sorely lacking in anything out of Stuttgart or Bavaria. The General had a plan to take on the smaller German sporty sedans, too, and Pontiac of the "We Build Excitement" era offered a midsize sedan packed with modern hardware at a great price: the 6000 STE. Here's one of the rarest 6000 STEs of them all, an all-wheel-drive-equipped '89 found in a Denver-area yard last week. Any 6000 STE is extremely hard to find today; when I wrote about a front-wheel-drive 1987 6000 STE back in 2018, desperate owners of these cars filled my inbox with requests — sometimes demands —  for parts that continue to this day. Many of them pleaded with me to help them find an all-wheel-drive version, and now I have managed to find one at Colorado Auto & Parts in Englewood, just south of Denver (in fact, the same yard at which I shot the '87). You may recall CAP as the old-school yard whose owners built the amazing airplane-engined 1939 Plymouth pickup a few years back.  The all-wheel-drive system on the 6000 STE was introduced for the 1988 model year, and it became standard equipment on the 1989 STE. At this time, the automotive industry had taken note of the success of the idiot-proof all-wheel-drive systems offered by AMC and Audi/Volkswagen; Toyota began selling Americans all-wheel-drive Camrys, Celicas, and Corollas, while Ford offered the Tempo and Topaz with optional AWD and Subaru was just beginning to make the switch from manually-selected four-wheel-drive to genuine all-wheel-drive around that time (it took a few more years for everyone to standardize on the 4WD/AWD terminology we use today, though). The 6000 STE AWD was intended to compete with such all-wheel-drive-equipped sedans as the Audi 80 ($23,610), Audi 90 ($28,840), and BMW 325iX ($30,750); its $22,599 price tag (about $50,700 in 2021 dollars) certainly made it seem like a bargain compared to those cars. In addition to the all-wheel-drive system, 1989 6000 STE owners got a digital instrument panel and more switches and buttons than the Space Shuttle.