1964 Pontiac Catalina 2+2 Two Doorhardtop Original--project on 2040-cars

Auto blog

Drive plays Smokey, Bandit with turbo Trans Am

The modern trend for powertrains can be summed up with the simple maxim: cut displacement and add forced induction. Whether you are looking at the just-introduced 2016 Chevrolet Cruze or a BMW M3, this adage holds true. However, Pontiac's attempt at the idea goes all the way back in 1980 with the Firebird Trans Am and its turbocharged 4.9-liter V8. Drive's Mike Musto takes out a 1981 example to explain what makes this largely forgotten muscle car so special, and it certainly isn't performance. While a 4.9-liter V8 might sound like a lot in the modern world, keep in mind that only few years before the second-generation Trans Am was available with up to a staggering 7.5-liters of displacement. Turbocharging of road cars in the early '80s was quite archaic by today's standards, and the Firebird only managed around 200 horsepower with this mill. Without much go, the turbo Trans Am made up for a lack of power with lots of show. As Musto points out, the famous flaming chicken adorns practically every surface you can see on the coupe, and boost lights on the hood illuminate when the turbo is spinning. Musto still finds a lot to like about the turbo Trans Am. He even calls it "Burt Reynolds as an automobile." Find out why the coupe is so special in this entertaining clip.

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Lutz dishes dirt on GM in latest Autoline Detroit

Bob Lutz sits down for Autoline Detroit - Click above to watch video after the jump
Autoline Detroit recently played host to Bob Lutz, and, as is always the case, the former General Motors vice chairman dished out some great commentary. Lutz was promoting his new book Car Guys vs. Bean Counters: The Battle for the Soul of American Business, and talk quickly turned to his role as it related to product development and high-level decision making at GM. While on the topic of brand management, Lutz revealed a few rather interesting tidbits about his former employer:
All Chevrolet vehicles were required to have five-spoke aluminum wheels and a chrome band up front, as part of the Bowtie brand's overall image.