2007 Mitsubishi Eclipse Gs Coupe 2-door 2.4l on 2040-cars

Auto blog

Mitsubishi recalling 166k cars, crossovers over stall risk

Mitsubishi is recalling 165,923 vehicles in the US because it's possible for the drive belt to detach from their engines, potentially causing a stall. Specifically, the campaign covers 2008-2011 model-year examples of the Lancer, Lancer Evolution (pictured above) and Outlander as well as the 2009-2011 Lancer Sportback and 2011 Outlander Sport. All of the affected models use some version of the brand's 4B1 four-cylinder engine.
According to the National Highway Traffic Safety Administration, the engine pulley can wear causing the drive belt to slip off. If this happens, the alternator, cooling fan and hydraulic power steering can all stop working, and obviously, any of those things could make driving unsafe. However, if the belt detaches, then a warning light should come on in the cabin.
To fix the problem, Mitsubishi dealers will replace the original belt with a redesigned rubber part and will inspect the pulley. If worn, it'll also be replaced free of charge.

Mitsubishi Mirage G4 sedan debuting in Montreal

Around this same time last year, Mitsubishi used the Montreal Auto Show for the North American introduction of its 2014 Mirage. This year, the Japanese automaker will reveal the sedan version of the subcompact wearing the Mirage G4 nameplate, according to the auto show's website and a couple of fresh teaser images.
We got our first look at this Mirage sedan as previewed by the Concept G4 at the 2013 Shanghai Motor Show, and the production version of that sedan ended up wearing the Attrage name in Thailand and other global markets. There's no official information from Mitsubishi at this time about the Mirage G4, but we wouldn't be surprised to see the small sedan follow the same path as the hatchback, showing up for a US debut at the New York Auto Show before going on sale in the fall. Check out the teaser images in the gallery below.

Mitsubishi recalling i-MiEV models for brake problem

Mitsubishi is issuing a recall for the 2010-2014 i-MiEV that affects 1,810 units of the little electric car, because it's possible for the brake vacuum pump to stop working. If this happens, the result would be longer stopping distances, according to the company. The affected models were built between September 15, 2009, and March 25, 2014.
While this is just a single recall, there are actually two things that can cause this brake problem on the i-MiEV, according to Mitsubishi's filing with the National Highway Traffic Safety Administration. First, bad programming in the EV-ECU could cause the system to "falsely judge that the relay contact point is stuck," according to the full NHTSA defect notice PDF. Second, the vacuum pump exhaust hole could be corroded and blocked due to being splashed with road salt. However, the company says that if either fault happens, the brake warning lamp would illuminate, and there would be an audible alarm.
Depending on which issue is affecting an owner's i-MiEV, Mitsubishi is going to reprogram the software, replace the pump or both. Scroll down to read the recall report from NHTSA.