2001 Mercury Sable Ls on 2040-cars

Auto blog

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

NHTSA investigating 500k Ford and Mercury cars for lighting failures

The Ford Crown Victoria and Mercury Grand Marquis might be long gone as new models in showrooms, but the National Highway Traffic Safety Administration might check them out yet again for a potential problem. At the urging of North Carolina Consumers Council, the agency may open another investigation into the front lighting control module on vehicles from the 2003-2005 model years, and NHTSA estimates the issue could affect 517,945 vehicles. If the module stops working, it can cause a complete failure of all forward lighting, including the headlights. NHTSA previously investigated the issue in 2008 and 2009 but found no need for a recall, according to Bloomberg. Ford also extended the warranty on the part to 15 years or 250,000 miles. To prompt this new request, the North Carolina Consumers Council received a letter from a woman experiencing the module's failure. Upon further investigation, the council found 604 complaints of this problem on NHTSA's website, including seven crashes. Furthermore, the group has alleged that dealers told customers that the parts to perform the replacement weren't available, despite the extended warranty. According to the government agency, "A defect petition has been opened to evaluate the issue and make a grant or deny decision." Ford spokesperson Kelli Felker tells Autoblog via email, "We will cooperate with NHTSA, as we always do." You can read the council's complete letter to the Feds in PDF format, here. INVESTIGATION Subject : Loss of headlamp/exterior lighting Date Investigation Opened: APR 01, 2015 Date Investigation Closed: Open NHTSA Action Number: DP15002 Component(s): EXTERIOR LIGHTING All Products Associated with this Investigation Vehicle Make Model Model Year(s) FORD CROWN VICTORIA 2003-2005 MERCURY GRAND MARQUIS 2003-2005 Details Manufacturer: Ford Motor Company SUMMARY: The Office of Defects Investigation (ODI) has received a petition from the North Carolina Consumers Council, Inc. requesting a defect investigation of an alleged defect condition resulting in headlight and/or exterior lighting failure on 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles. The petition letter is attached for review. The petitioner alleges a defect in the lighting control module that powers the headlights which can result in the loss of vehicle headlights and/or all exterior lighting while driving. ODI has previously investigated this issue under PE08-066 which was closed without a defect finding.