Luxury 3.0l Cd Front Wheel Drive Tires - Front All-season Aluminum Wheels Abs on 2040-cars
Moreno Valley, California, United States
Mercury Montego for Sale
- 1973 mercury montego
- 1970 mercury montego(cyclone spoiler clone) 302v8 3-speed~rock solid~super clean(US $9,995.00)
- 1973 mercury montego mx brougham 5.8l
- 2005 mercury montego runs & drive can drive it home
- 2006 sedan used v6 3.0 liter 6-spd automatic fwd leather red(US $11,882.00)
- Beautiful original 1973 mercury montego mx brougham survivor(US $6,700.00)
Auto Services in California
Yuba City Toyota Lincoln-Mercury ★★★★★
World Auto Body Inc ★★★★★
Wilson Way Glass ★★★★★
Willie`s Tires & Alignment ★★★★★
Wholesale Import Parts ★★★★★
Wheel Works ★★★★★
Auto blog
NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder
Fri, 11 Jul 2014There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.
Curtain officially comes down on Mercury as dealers remove signage
Mon, 03 Jan 2011The process of shutting down the Mercury is complete. Ford officially made the decision to close its mid-level brand in June of 2010. In the months that followed, Ford offered its dealers money to stop selling the cars, with production shutting down in September. The last Mercury, a Mariner, rolled off the assembly line in the beginning of October and former spokesperson Jill Wagner said her good-byes to both the car and her job. Now the last piece of the brand has come down as dealers are removing any and all Mercury signage from their lots.
[Source: Detroit News]Read | Permalink | Email this | Comments
Ford finds flex-fuel engine design plays big role in emissions output
Mon, Jan 6 2014How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.