2010 Mercury Milan Base on 2040-cars

Auto blog

Jill Wagner retired as Mercury spokeswoman

Jill Wagner has officially given up her crown as the queen of Mercury. With the Ford middle child on its way to the scrap heap, Wagner no longer has any automotive hardware to promote. Given her varied talents, we wouldn't be surprised to see her pick up where she left off with another automaker.
And here you thought you'd never be upset about Mercury's passing.
Thanks for the tip, Gregg!

Junkyard Gem: 1955 Mercury Montclair Coupe

I find plenty of 1950s Detroit vehicles in the big self-service car graveyards I frequent, but most of them are fairly ordinary sedans that never stood much chance of getting fixed up and put back on the road. Such is not the case with today's Junkyard Gem, which is a top-trim-level, heavily optioned hardtop coupe from one of the most desirable model years of the tailfins-and-chrome postwar era. Nearly every Mercury model ever made was a Ford model with some cosmetic changes applied, and the '55s looked very similar to their mechanically identical Ford brethren. In 1955, the new Mercury came in three trim levels: the entry-level Custom, the medium-zoot Monterey, and the glitzy Montclair. Each was available as a hardtop coupe and four-door sedan, with wagon versions of the Custom and Monterey. The Montclair could be purchased as a convertible or with the wild "Sun Valley" glass roof. The Montclair got its own line of hallucinogenic two-tone interiors, in order to make the daily lives of Europeans feel even more gray and penurious (the UK only dropped food rationing in 1954, and the two Germanies were still clearing the rubble of their blown-up cities). This car's upholstery has been bleached by decades of sitting outside in the harsh High Plains climate, but it started out as vivid red and white "Chromatex" fabric. The list price on this car was $2,631, or about $29,200 in 2022 dollars. The Sun Valley and convertible Montclair each cost $2,712 ($30,100 today). Ford didn't offer a corresponding hardtop coupe in 1955, though the Fairlane Crown Victoria two-door did look extremely snazzy (and cost a mere $2,302— $25,545 now— with the same V8 engine as the Monterey). Meanwhile, Oldsmobile offered the handsome 88 Super Holiday Coupe for $2,714, though the Montclair had the more powerful engine. Oldsmobile had been selling new cars with overhead-valve V8s since the 1949 model year, while Ford didn't ditch the Model A-era flathead V8 for new U.S.-market cars until the 1954 model year (you could buy a new Simca Esplanada in Brazil with an Ardun-headed Ford V8-60 all the way until 1969). GM's Chevrolet Division got all the press in 1955 with the introduction of the brand-new small-block V8 engine, but Ford's 292-cubic-inch (4.8-liter) Y-Block V8 made more power than the 265-cube (4.3-liter) Chevy and the 324ci Olds Rocket 88.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.