Find or Sell Used Cars, Trucks, and SUVs in USA

2003 Mercury Grand Marquis Ls Sedan 4-door 4.6l on 2040-cars

US $4,995.00
Year:2003 Mileage:64361
Location:

Collingswood, New Jersey, United States

Collingswood, New Jersey, United States
Advertising:

VERY LOW MILEAGE FOR A VEHICLE OF THIS AGE COMPARED TO OTHERS THAT HAVE BEEN SOLD/LISTED ON EBAY IN THE RECENT PAST.

This vehicle will need to be picked up.

Auto Services in New Jersey

Williams Custom Tops-Interiors ★★★★★

Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery, Automobile Accessories
Address: 910 Woodbourne Rd, Fieldsboro
Phone: (215) 757-3100

Volkswagon of Langhorne ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 1862 E Lincoln Hwy, Pennington
Phone: (215) 741-4100

Vip Honda Honda Automobiles ★★★★★

New Car Dealers
Address: 542 Somerset St, Fanwood
Phone: (908) 753-6071

Tri State Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 15511 Liberty Ave, West-New-York
Phone: (718) 206-0143

Solveri Collision Center ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 2300 Route 88, Asbury-Park
Phone: (732) 202-7448

Scotts Auto Service ★★★★★

Auto Repair & Service
Address: 161 Kinderkamack Rd, Haworth
Phone: (201) 391-3433

Auto blog

Feds open investigation into Chevy Express, Ford Freestar rust issues

Wed, 28 Dec 2011

'Tis the season... for road salt. And with that, comes rust. And what does rust bring? Well, for Ford and General Motors, a National Highway Traffic Safety Administration investigation. According to The Detroit News, NHTSA is looking into potential recalls issues with Chevrolet Express vans and Ford Freestar minivans.
The feds have received five complaints that rust has caused leaking fuel filler pipes on 2003 Express vans. Separately, seven complaints have been filed over excessive rust in the rear wheel wells of 2004 Ford Freestar and Mercury Monterey minivans. The Freestar and Monterey went out of production in 2007. Neither issue has resulted in any crashes or injuries, according to the report.

Ford finds flex-fuel engine design plays big role in emissions output

Mon, Jan 6 2014

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.

NHTSA investigating Ford's solution to May 2014 power steering recall

Tue, Apr 7 2015

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.